Tapco products company pro brake operating instructions.
P r o 1 9 a n d p r o 1 4 b r a k e s brake buddy™ instant roll forming tool. Side-winder™ works in tandem with all pro series brakes. Pro™ cut-off quickly, safely, and easily makes factory quality cuts in coil stock, sheet metal, and vinyl siding right on your brake. Snap stand™ heavy duty transpor...
P r o 1 9 a n d p r o 1 4 b r a k e s pro tm cut-off quickly, safely, and easily makes factory quality cuts in coil stock, sheet metal, and vinyl right on your port-o-bender. • produces straight, square cuts. Reduces scrap and eliminates knifing damage to costly bending hinges. • lightweight aluminum...
P r o 1 9 a n d p r o 1 4 b r a k e s secure with 1 / 4 -20 lock nut hinge clip installation the hinge clip keeps the moving hinge in position for ease of aligning material. It can also prevent rippling of the coil during cut off operations. To install hinge clip, locate predrilled hole on bottom ce...
P r o 1 9 a n d p r o 1 4 b r a k e s basic hemming and folding 1 insert the material you wish to hem into your port-o-bender. 4 remove the material from the port-o-bender. 3 bend as far as you can go. 5 position the bent edge of the material in the hemming pocket on top of the anvil. 6 lift the ben...
P r o 1 9 a n d p r o 1 4 b r a k e s step 1 to open each leg set, push in the snap button and move each leg outward to the working position. Figure 1a below shows the leg set as shipped while figure 1b shows the leg set open (working position). Make sure that the snap button pops up to lock each le...
P r o 1 9 a n d p r o 1 4 b r a k e s step 1 using the 1/4-20 bolts and lock washers provided, fasten the brake mounts to the leg set. Depending on which brake you’re using, choose the correct holes as shown in the figure at right. Step 2 the snap buttons will be towards the working side of the brake...
1 2 7 4 5 3 6 1 2 7 4 5 3 6 3 2 4 5 1 down down up up up up down 2. Fascia trim down 1 2 3 5 4 up 1 2 3 5 4 7. Counter flashing 3. One piece soffit mitre 8. Brick frieze 5. Soffit or frieze trim 9. “f” channel/inside corner 3 2 4 5 1 5 4 2 3 1 5 4 2 3 1 4. Rake trim with “j” channel up up down dow...
Item # description 10094 1/4-20 hex flange nut 10351 lifting handle assembly 10417 8'6" moving hinge 10419 10'6" moving hinge 10421 12'6" moving hinge 10177 8'6" base hinge 10433 8'6" hd base hinge 10435 10'6" base hinge 10438 10'6" hd base hinge 10183 12'6" base hinge 10452 8'6" locking handle 1045...
