Tapco PRO14 Operating Instructions Manual - Hinge Clip Installation
P R O 1 9 a n d P R O 1 4 B r a k e s
Secure
with
1
/
4
-20
Lock Nut
Hinge Clip Installation
The Hinge Clip keeps the Moving Hinge in position for ease of
aligning material. It can also prevent rippling of the coil during
cut off operations.
To install Hinge Clip, locate predrilled hole on bottom center
of Moving Hinge. Align holes in Clip and Hinge as shown and
insert Phillips head screw provided.
Note: You must use hinge clip when using Pro Cut-Off.
Faspin
Locking Handle
Handle
Plug
Hemming
Handle
Hex Bolt
Hemming Handle Installation
Attach the Hemming Handle over the Han-
dle Plugs and secure them with Faspins.
Now tighten the 3/8
”
Hex Bolts with a 9/16
”
wrench. Handle can be detached from now
on by simply removing the Faspins.
Insert Handle Assembly into hole in bot-
tom of Moving Hinge. Align hole in hinge
with Handle Plug and insert screw using
T-Handle Hex Key as shown. Secure with
1/4-20 Lock Nut.
Lifting/Bending Handle Installation
Repeat for other handle(s). To remove
handles, simply release Faspins. Always
use more than one handle when bending.
The Hemming Handle Assembly includes:
(1) Hemming Han-dle, (2) Handle Plugs, (2)
Faspins, (2) Hex Bolts.
Insert Hex Bolt through Locking Handle
of your Port -O-Bender and into base of
Hemming Handle as indicated using the
3/8
”
Hex Bolts provided. HAND TIGHTEN
ONLY. Repeat for other side.
Remove the combination Lifting/Bend-
ing Handles from each end of the Port -
O -Bender by removing the Faspins as
shown.
Faspin
1
/
4
-20 x 1
1
/
2
"
Screw
Handle
Plug
Moving
Hinge
1
/
4
-20
Lock Nut
T-Handle
Hex Key
Lifting/
Bending
Handle
Setting Up Your PRO Brake
3