Tapco S1001N-1 Operating Instructions - page 2
2
WWW.TAPCO-EUROPE-TOOLS.COM
SPARE PARTS FOR SD5-1 AND S1001N-1
S E R V I C E T I P S
Before working on machine disconnect from power supply by
removing plug from socket.
Wear protective glasses!
1. One drop of oil between knife (11) and head-casting (1) keeps
the spacing shims (15) in place.
2. Dismantle Spring cover (20) and take spring out (19).
3. Take circlip (16) and washer (17) off.
4. Push knife pin (18) out of casting.
5. Take knife out of housing
6. Attention, do not exchange the spacing shims (15).
7. Place the knife inside the housing feed shims in on one side
and push knife pin (18) into housing up to the middle of the
knife.
8. Feed the shims on the other side of the knife.
9. Push knife pin in completely, and secure washer (17) and
circlip (16) again.
10. Assemble spring (19) and spring cover (20).
11. Between the knife (11) and the jaws (10) should be some
distance, approximately 0.1 mm on each side. Knife (11) must
be placed tight in the head casting.
12. Adjustment for the play between the jaws. (a): 0.1 to 0.15 mm.
* o p t i o n a l
13. If knife has contact with the jaws on both sides, adjust with
screws in the head casting. If a burr is on the material, adjust
the space between the knife and the jaws.