Targa RT 7100 Owner's Manual - Troubleshooting
EN-17
EN
Important Note:
•
Do not drop or jolt the unit.
•
If the unit does not work properly, press the “ RESET ”
key once to restart. (The Reset key is located inside
the battery compartment.)
•
If password is set, the User needs to enter password
to access the main menu. Enter “AAAAA” if you forget
the password.
Troubleshooting
4
Q : My TARGA RT 7100 is not working!
A : Please make sure that you have inserted the provided
rechargeable batteries with correct polarity and that they
are charged. For further details, please refer to the “
1.4
Battery Installation and Charging ” section of this manual.
A : If your TARGA RT 7100 stops, please press the “ RESET ”
button inside the battery compartment. For details, please
refer to the “
2.1 Panel Calibration ” section of this manual.
Q : I have installed a code from the provided code
list for my device but the remote is not working
or only partly working with my device.
A : The selected code is not matched with your device: you
must try another code if it is available on the code list. Or
you have to go through the “ Auto Search ” to locate
another possible code. Or you can simply learn the original
remote to your TARGA RT 7100 by learning function. For
details, please refer to “
2.7 Configuration/Setting Up the
Unit ”.
Q : I have copied my original remote to TARGA RT
7100. But I found that some of the commands only
function occasionally.
A : Your original remote may carry dual signal commands. You
must go through the section “
2.7 Configuration/Setting
Up the Unit — Dual Signal Learning ” and program again.
Q : I cannot move a key to another location.
A : You must make sure that the selected key type is identical.
You cannot exchange key position with different key type.
For details, please refer to “
3.1.3. Move Key ” section.
Q : The backlit of the LCD is not working.
A : You must make sure that you have selected either “ By
sensor ” or “ Always On ” in the Remote Setting menu. For
details, please refer to “
3.3 Remote Setting ” section.
Q : How can I prevent someone to editing/changing
the setting of my TARGA RT 7100?
A : Simply activate the “ Password ” function to lock your
remote. For details, please refer to “
3.3.4. Password ”
section.
3.7 Interactive Help Screen
In menu mode, there is a help icon (
?
) in the top
right corner of screen. It provides help information for
each sub-level of menu.