Targus PAWM10 User Manual - Troubleshooting
11
Targus Wireless RF Mouse
Troubleshooting
What do I do if the RF mouse does not work?
• Make sure that the polarity of the batteries is correct. The
positive (+) and negative (-) ends of each battery must match
the positive (+) and negative (-) connections in the battery
housing.
• Check that the receiver’s USB connector is firmly attached
to the USB port on your computer.
• Verify that the device drivers are installed.
• Make sure you have established a radio link between the
mouse and its receiver. See “Establishing a Communications
Link (All RF Mouse Models)” on page 6
When I use the RF mouse, other wireless devices work
more slowly or fail temporarily – what should I do?
The mouse may cause interference with any cordless,
radio-based device that operates at 27 MHz, such as a
telephone, baby monitor, or toy. To reduce interference, move
the mouse’s receiver and the base unit of the affected device as
far away from each other as possible.
Mouse Standby
Current
Below 4mA
Mouse Sleep Mode
Current
Below 50uA
Modulation Type
FSK
Transmission Rate
4K bps
Error Detection
8-bit CRC