Targus PAWM10 User Manual - (All Rf Mouse Models)
6
Targus Wireless RF Mouse
Establishing a Communications Link
(All RF Mouse Models)
The RF mouse has 256 identification codes that allow the
mouse and its receiver to operate without interference from
other radio frequency devices.
After your computer detects the USB receiver and the driver
software is installed, you must establish a communications link
between the mouse and its receiver BEFORE you can use the
mouse. To establish this link, you need to set the identification
code so that the mouse works properly. To do this, follow the
instructions for your mouse model.
Mouse Model PAWM10
Make sure that your computer is turned on and has detected the
USB receiver before you establish a communications link.
1 Press and release the link button on the receiver.
Receiver
The USB connector rotates 90 degrees to facilitate easy
connection to your computer.
The receiver’s red status light blinks when the receiver is
activated.
2 Press and release the reset button, located on the bottom of
the mouse.
You are now ready to use the RF mouse.