Targus Wireless RF Mouse User Manual - Targus Wireless Rf
2
TARGUS WIRELESS RF
MOUSE
Introduction
Congratulations on your purchase of a Targus Wireless RF
Mouse. This ergonomically designed mouse uses a radio
frequency (RF) link that enables you to use the mouse
anywhere within three feet of its receiver. No line-of-sight
between the mouse and its receiver is required.
This user’s guide describes how to connect the mouse receiver
to your computer, install default software drivers and set up the
radio link.
System Requirements
To use the RF mouse, your computer must meet the following
hardware requirements and run one of the operating systems
listed below.
Hardware
• PC with an Intel
®
Pentium
®
processor or equivalent and a
hard disk drive
• USB interface
Operating System
• Windows
®
98/Me/2000/XP
NOTE: The third button and the scrolling wheel only work with
the operating systems listed above. If you use the RF mouse
with a different operating system, it will lose its enhanced
features and function as a standard, two-button mouse.