Tascam CD-400U Owner's Manual - page 5
TASCAM CD-400U
5
Wireless equipment precautions
Compliance of radio transmitter and interference
This product has the function of broadband transmitter
using 2.4 GHz Band.
Use frequency range: 2400 MHz - 2480 MHz
Maximum output power: Bluetooth® Class2 (less than
2.5 mW)
CAUTION
Use only in the country where you purchased the prod-
uct.
• Authorization of wireless devices are different in coun-
tries or regions.
• Depending on the country, restrictions on the use of
Bluetooth wireless technology might exist.
CAUTION
Changes or modifications to this equipment not expressly
approved by TEAC CORPORATION for compliance could
void the user’s authority to operate this equipment.
Radiation Exposure requirements
This equipment meets the regulation, which is recog-
nized internationally, for the case of human exposure to
radio waves generated by the transmitter.
8
Model for U.S.A
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2)
this device must accept any interference received, includ-
ing interference that may cause undesired operation.
Labeling of authorization
FCC ID: XEG-CD400U
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to pro-
vide reasonable protection against harmful interference
in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction
manual, may cause harmful interference to radio com-
munications. However, there is no guarantee that inter-
ference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the follow-
ing measures.
a) Reorient or relocate the receiving antenna.
b) Increase the separation between the equipment and
receiver.
c) Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
d) Consult the dealer or an experienced radio/TV technician for
help.
FCC Radiation Exposure Statement
This device complies with FCC radiation exposure limits
set forth for an uncontrolled environment and it also
complies with Part 15 of the FCC RF Rules.
This equipment must be installed and operated in accor-
dance with provided instructions and the antenna(s) used
for this transmitter must be installed to provide a separa-
tion distance of at least 20 cm from all persons and must
not be co-located or operating in conjunction with any
other antenna or transmitter.
End-users and installers must be provided with anten-
na installation instructions and consider removing the
no-collocation statement.
8
Model for Canada
Compliance of radio transmitter
This device complies with Industry Canada’s license-ex-
empt RSSs. Operation is subject to the following two con-
ditions:
(a) This device may not cause interference; and
(b) This device must accept any interference, including
interference that may cause undesired operation of the
device.
Labeling of authorization
IC: 1559C-CD400U
Compliance of interference
This Class B digital apparatus complies with Canadian
ICES-003.
Labeling of compliance
CAN ICES-3(B)/NMB-3(B)