Task Force 24053 Operator's Manual - page 8
KNOW YOUR 7.2V CORDLESS SHEAR
8
Battery charger
Cutting blade
Trigger switch
Pole
Plug
Connector
Handle
Lock-off button
OPERATING INSTRUCTIONS
Install the blade sheath (Fig. 1):
1. Align the blade sheath (2) with the cutting blades (1) on
the shear.
2. Slide the blade sheath (2) over the blades, then insert
two button (3).
3. To remove the sheath, pull out two button (3) and slide
the blade sheath.
Blade Sheath
Fig. 1
1
1
2
2
The shear has a Lock-off button (2) and a trigger
switch (1). Both must be used to operate the shear:
1. Place one hand on the the handle and depress the lock
ON/OFF button to the right (2).
2. Squeeze the trigger switch (1) to turn on the shear.
3. Release the trigger switch to turn off the shear.
Power Switches (Fig. 2)
Install wheels
Fig. 2
3
Blade Sheath
Wheels
1. Screw wheel into shear body as shown.