Taski swingo 150E Manual - page 11
67
Cleaning the recovery tank and fresh water tank
Wash out the motor protection filter
Washing out the filter housing and the float
Cleaning the sponge and pump protection filter
Cleaning / Replacing the sponge filter
Replacing pump protection filter
Cleaning / Replacing the brush roller
Replacing the brush roller
• Rinse the recovery tank and the fresh water tank thorough-
ly with clean water.
• Remove the motor protection filter
from the transparent filter protection
above the filter housing.
• Wash out the motor protection filter
under running water.
• After washing it out, wring out the
motor protection filter so that the wa-
ter can flow out.
Attention:
Do not reinsert the motor protection filter
before it is completely dry.
• Remove the motor protection filter from the flter protection
before you wash out the filter housing.
• Wash out the filter housing and the
float (X), which is located on the un-
derside of the filter housing, under
running water.
• Reinsert the dry motor protection fil-
ter.
M A X
WATER LEVEL
LIVELLO ACQUA
WASSER NIVEAU
NIVEAU DE L`EAU
NIVEL DE L`AGUA
Temperature
+5°C + +35°C
+41°F + +95°F
2
3
1
1
2
x
2
1
• Place the filter housing on the tank
and lock it into place.
• Remove the light-blue sponge filter
using pliers.
Notice:
Wash out the sponge filter monthly.
Replace the sponge filter as necessary.
• The pump protection filter should be
replaced once a year.
Attention:
Danger of injury due to sharp objects.
Wear gloves for your own protection!
Notice:
Check the brush roller for wear after every
use.
Bristles that are too short or a damaged
brush roller could lead to damage to the
floor and impair the cleaning result!
• Place the machine on its side so that
the brush holders on the side are
pointing upwards.
• Press the rotation lock (1) and turn
the brush holder (2) counterclock-
wise and pull it out of the housing (3)
in order to remove it.
• Take out the brush roller.
• Clean the brush roller under running
water.
2
1
3
EN