TATA Motors Nano Owner's Manual & Service Book - Quick Heating :
26
Normal Heating : (Only on HVAC)
(For vehicles fitted with HVAC)
Knob 'A' - At suitable position as per
requirement
Knob 'B' - Suitable blower speed
Knob 'C' - Suitable temperature
position
AC - OFF
Air Circulation - Fresh mode.
Quick Heating :
All settings as explained before
except air circulation switch to
recirculation.
Once vehicle is heated, switch back
to fresh mode.
Never rev-up the engine in cold
weather to achieve faster heating.
Normal Cooling :
Knob ‘A’ - Towards face
Knob ‘B’ - Desired blower speed
position
Knob ‘C’ - Towards blue dot as
required. (Not for AC version)
Knob ‘D’ - AC ON
Switch ‘E’ - suitably as explained
(Not for AC version)
Quick Cooling :
Switch ‘ON’ the AC and keep the
blower at maximum speed. Keep air
direction in face mode. All vents
should be opened completely. Keep
the air circulation knob in the
recirculation mode and temperature
control switch in the maximum
cooling (Blue) position (For HVAC
only). At maximum cooling, AC trips
off automatically when the desired
temperature is achieved.
•
In case you find reduction in air
flow or foul smell in the
passenger compartment clean
the evaporator and air filter.
If your car is left in the sun with
windows closed, inside temperature
increases. To achieve quick cooling
effect open the windows slightly
while you operate the AC.
Once temperature inside the car has
come down sufficiently, close the
windows and change air circulation
suitably to fresh or recirculation
mode.
Demisting :
(Only on HVAC)
In rainy season or in areas of high
humidity, mist formation inside
windshield glass may be observed.
To clear mist, dehumidified air is
passed on the windshield glass.
First start the engine and accelerate
to warm up.
Knob 'A' - Towards windshield
Knob 'B' - Suitable speed
Knob 'C' -At suitable temperature
Knob ‘D’ - AC ON
Switch 'E' - Suitable mode.
Once the windscreen has become
clear, change to suitable setting.
HVAC & AIR CONDITIONING