Taylor 337 Operator's Manual - Safety
5
050817
Safety
We at Taylor Company are concerned about the safety of the
operator when he or she comes in contact with the freezer
and its parts. Taylor has gone to extreme efforts to design and
manufacture built-in safety features to protect both you and
the service technician. As an example, warning labels have
been attached to the freezer to further point out safety
precautions to the operator.
IMPORTANT -- Failure to adhere to the following
safety precautions may result in severe personal injury.
Failure to comply with these warnings may also damage the
machine and its components. Component damage will result
in part replacement expense and service repair expense.
To Operate Safely:
DO NOT operate the freezer without reading this
operator’s manual. Failure to follow this instruction may result
in equipment damage, poor freezer performance, health
hazards, or personal injury.
S
DO NOT operate the freezer unless it is properly
grounded.
S
DO NOT attempt any repairs unless the main
power supply to the freezer has been
disconnected.
S
DO NOT operate the freezer with larger fuses
than specified on the freezer data label.
Failure to follow these instructions may result in electrocution
or damage to the machine. Contact your local authorized
Taylor Distributor for service.
DO NOT use a water jet to clean or rinse the freezer.
Failure to follow this instruction may result in serious
electrical shock.
S
DO NOT allow untrained personnel to operate
this machine.
S
DO NOT operate the freezer unless all service
panels and access doors are restrained with
screws.
S
DO NOT remove the door, beater and blades, or
drive shaft unless all control switches are in the
OFF position.
S
DO NOT put objects or fingers in door spout.
Failure to follow these instructions may result in
contaminated product or severe personal injury to fingers or
hands from hazardous moving parts.
USE EXTREME CAUTION when removing the
beater assembly. The scraper blades are very sharp and
may cause injury.
This freezer must be placed on a level surface.
Failure to comply may result in personal injury or equipment
damage.
DO NOT obstruct air intake and discharge openings:
A minimum of 6” (152 mm) air space is required on both sides
and rear, and 4--1/4” (108 mm) on bottom. Failure to follow
this instruction may cause poor freezer performance and
damage to the machine.
This freezer is designed to operate indoors, under normal
ambient temperatures of 70
_
--75
_
F (21
_
--24
_
C). The
freezer has successfully performed in high ambient
temperatures of 104
_
F (40
_
C) at reduced capacities.
NOISE LEVEL: Airborne noise emission does not exceed 78
dB(A) when measured at a distance of 1.0 meter from the
surface of the machine and at a height of 1.6 meters from the
floor.