Taylor C706 Service Manual - page 25
22
Controls
Models C706 & C707
6. Ten seconds later, the pump relay closes.
7. Three seconds later, the pump relay opens and
the mix light turns off.
8. Ten seconds later, the beater motor relay
closes.
9. Three seconds later, the beater motor relay
opens and the STANDBY light turns off.
10. Ten seconds later, the compressor relay closes.
11. Three seconds later, the compressor relay
opens and the wash light turns off.
12. All lights are off and a tone sounds for three
seconds. This designates the end of the first
section.
If all or most of the power board relays fail to close, the
logic panel is defective. If only one relay fails to close,
the power board is defective. This test can be used to
determine if a problem exists with the logic panel, the
power board, or elsewhere in the freezer. In other
words, if during the test the beater relay closes on the
power board, but the beater motor contactor does not
operate, the problem occurs after the command
reaches the power board.
Self-Test -- Part II
When the first section of the self-test is complete, the
control will advance to the starting point of the second
section. The technician will have to complete this
portion of the test. The first part of this section verifies
the function of the control potentiometers (adjustment
screw).
During this test, the MIX, STANDBY, WASH, AUTO,
and PUMP lights function in direct relationship with the
“MIN” and “MAX” adjustments of the potentiometer. In
other words, when the adjustment screw is turned all
the way to “MIN”, the MIX light will be lit. When the
adjustment is turned all the way to “MAX”, the PUMP
light will be lit. If the screw adjustment is made between
the “MAX” and the “MIN” adjustment, one of the other
lights will illuminate depending on the adjustment.
These lights create a bar graph which is directly related
to the product temperature. “MIX” is warm and
“PUMP” is cold.
1. The SET POINT light is lit, indicating that the
control is reading the soft serve viscosity
potentiometer.
2. Rotate the adjustment screw back and forth
from “MIN” to “MAX”. The bar graph should
travel accordingly. This indicates that the
potentiometer is functional.
If the bar lights do not react, the logic panel is
defective.
Important: If the freezer’s controls have been set
previously, return the adjustment to its original
position. For example, if the WASH light was lit
before an adjustment screw was rotated, before
going to the next step, rotate the adjustment
screw until the WASH light is lit again.
3. Press the MIX key once.
4. The MIX LOW light is lit, indicating that the
control is reading the MIX potentiometer.
5. Rotate the adjustment screw as in Step 2.
6. Press the MIX key once.
7. The MIX OUT light is on, indicating the control
is reading the STANDBY potentiometer.
8. Rotate the adjustment screw as in Step 2.
9. Press the MIX key once.
10. The MIX LOW light is lit, indicating that the
control is reading the “MIX 1” terminal.