Taylor C902 Operating Instructions Manual - page 23
19
Model C902
Operating Procedures
081204
Draining Product From The
Freezing Cylinder
Step 1
Place the power and the control switches in the OFF
position as far ahead of cleaning time as possible. This
will allow frozen product to soften for easier cleaning.
Step 2
Remove the hopper cover.
Step 3
If local health codes permit the use of rerun, place
a sanitized, NSF approved stainless steel rerun
container beneath the door spout. Place the power
switch in the ON position and the control switch in the
WASH position. Open the draw valve. When all the
product stops flowing from the door spout, close the
draw valve. Place the control switch in the OFF
position. Place the sanitized lid on the rerun container
and place it in the walk--in cooler.
Note: If local health codes DO NOT permit the use
of rerun, the product must be discarded. Follow the
instructions in the previous step, except drain the
product into a mix pail and properly discard the mix.
Repeat these steps for the other side of the unit.
ALWAYS FOLLOW LOCAL HEALTH CODES.
Rinsing
Step 1
Pour two gallons (7.6 liters) of cool, clean water into the
mix hopper. With the brushes provided, scrub the mix
hopper and the mix inlet hole.
Figure 28
Step 2
With a pail beneath the door spout, place the control
switch in the WASH position. Open the draw valve.
Drain all the rinse water from the freezing cylinder.
When the rinse water stops flowing from the door
spout, close the draw valve and place the control
switch in the OFF position.
Repeat this procedure until the rinse water being
drawn from the freezing cylinder is clear.
Repeat these steps for the other side of the unit.
Hopper Cleaning
Step 1
Prepare a pail of approved 100 PPM cleaning solution
(examples: 2--1/2 gal. [9.5 liters] of Kay--5R or 2 gal.
[7.6 liters] of Stera--SheenR). USE WARM WATER
AND
FOLLOW
THE
MANUFACTURER’S
SPECIFICATIONS.
Step 2
Pour the cleaning solution into the hopper. Allow it to
flow into the freezing cylinder.
Step 3
While the solution is flowing into the freezing cylinder,
brush clean the mix hopper and the mix inlet hole.
Step 4
Place the control switch in the WASH position. This will
agitate the cleaning solution in the freezing cylinder.
Figure 29
Step 5
Place an empty pail beneath the door spout. Open the
draw valve. Draw off all the cleaning solution. When
the solution stops flowing from the door spout, close
the draw valve. Place the control switch in the OFF
position.
Repeat these steps for the other side of the unit.