TC Electronic BH250 User Manual - Operation – Rear Panel
Other manuals for BH250:
Manual
of
14
8
operatIon – rear panel
MAINS IN – Power Input & POWER Switch
The switch-mode power supply accepts voltage from 100V to
240V
The ground pin of the power supply unit must be
connected in order to avoid voltage differences between
e.g. the PA and the BH250 Head.
SPEAKER OUT
Use the SPEAKER OUT connector for connecting speaker
cabinets. The type of plug is Speakon and you MUST use
speaker cables. Do NOT use instrument cables!
Use a cabinet configuration with a minimum load of 4 Ohm.
Examples:
2 x 8 Ohm (in parallel)
1 x 4 Ohm
PEDAL input
Connect a TC Electronic SWITCH 3 (optional) and activate/
deactivate TonePrint and Tuner mute.
SWITCH-3
Switch 1 - Mute
Switch 2 - TonePrint on/off
Switch 3 - TonePrint A/B (alternate between two TonePrints)