TC Electronic BH250 User Manual - Operation – Rear Panel
9
EN
operatIon – rear panel
BALANCED OUT
Use the BALANCED OUT XLR to connect the BH250 to the PA
when you play on stage, or to connect your amp to a recording
device when you are in the studio.
To determine where in the signal chain the signal for the
balanced output should be tapped, use the PRE/POST switch
located right beside the BALANCED OUT jack.
PRE – the signal is tapped before the EQ and TONEPRINT effect
POST – the signal is tapped after EQ and TONEPRINT effect.
The BH250 MUTE button mutes the balanced output
as well as the speaker and headphones outputs
allowing you to tune up with no sound in your own rig
or in the PA – provided, of course, that you use the
BH250 Head’s balanced output instead of a
conventional line-driver.
USB
Connection for computer for TonePrint upload and software
updates.
AUX IN
The AUX IN is a stereo auxiliary input. Any signal present on
the AUX IN phone jacks is played back through all outputs. This
allows you to play along with a rehearsal track when checking
out new stuff or when practicing to the beat of a metronome
click.
The included “mini jack to mini jack cable” allows you to use an
iPod®, iPhone® or any other consumer playback device as a
source for rehearsing.
PHONES (MUTING)
This is a 1/8” connector for headphones. With a mild speaker
filter applied to the bass sound, our studio quality headphone
amp caters for a great headphone sound.
The headphone output also plays back any signal connected to
the AUX IN input jack.
This feature allows you to play along with e.g. an MP3 player
(e.g. an iPod®), a signal from a computer sound-card or any
other audio source playing background tracks – this is excellent
for rehearsing or checking out new tracks without disturbing the
neighbors.