TCO 95 V7 Super Slim Line L23.1A Instructions Manual - page 4
•
Power
- LCD Monitor Rated : 12 V d c , 5.5A maximum.
- Use the type of power indicated on the marking label.
•
Adapter
-Only use an adapter designed for the LCD monitor
(Ault MW116KA1249F51 or Delta ADP-70RB)
-IMPORTANT : Use o f another type of adap ter will result in
malfunction and /or danger.
•
Plugs
- Do no t remove any parts of the monitor’s three pronged
power plug.
- Disconnect the power plug from the AC outlet when the
monitor will not be used for an indefinite period of time.
•
Power and extension cords
- Use the p roper power co rd with the correct plug type. If
the p ower source is 120V AC, use a power co rd that has UL
and CSA approvals. If the power source is a 240V AC supply
use the tandem (T blade) type attachment plug with a ground
cond uctor power cord that meets the resp ective Europ ean
country’s safety regulations, such as VDE for Germany.
- A certified p ower supp ly cord not lighter than ord inary
po lyvinyl chlorid e flexib le co rd according to IE C 60227
(d esignatio n H05VV-F 3G 0.75mm
2
or H05VVH2-F23G 0.
75mm
2
) sho uld be used. Alternative a flexible co rd be of
synthetic rubber according to IEC60245 (designation H05RR-
F3G, 0.75mm
2
) shall be used.
- Do not overload wall outlets or power cords. Be sure that
S A F E T Y I N S T R U C T I O N S
III
the total o f all units plugged into the wall o utlet does not
exceed 7 amperes.
- Be sure that the total ampere ratings on all units plugged
into the extension cord does not exceed the rating o f the
cord.
- If the monitor power supply cord requires a connection to
the P C instead of the wall outlet, this equipment is to be used
with a UL appro ved computer which has a receptacle rate of
100-240V AC, 50/60Hz, 1.5A (minimum).
- Do not place anything on the power cord. Do not locate this
product where a person may walk or trip over the cord.
•
Environment
- Place the monitor on a flat and leveled surface.
- Place the monitor in a well-ventilated area.
- Keep the monitor away from:
Rain or water
Excessive heat, cold or humidify.
Areas exposed to direct sunlight.
Dusty surro undings.
E quipment that generates strong magnetic fileds.
•
Warning
1.
Do not use in the p resence of flammable anesthetics.
2.
Do not obstruct the ventilating ho les.
3.
Do not use if the product has been exp osed to liquids.
4.
Do not use if the cable have been frayed or damaged.
5.
Only connect to the device which has SELV Circuitry or
Medical approval.
2