TCS Basys Controls SZ1009 User Manual - page 3
R
2800 LAURA LANE
l
MIDDLETON, WI 53562
l
(800) 288-9383
l
FAX (608) 836-9044
l
www.tcs-basys.com
3
Setup
Note: If using remote sensor(s), the calibration may need to
be adjusted. See “Checkout and Troubleshooting” section.
TEMPERATURE SENSOR SELECTION
The dipswitches in the cover (shown above) must be set when
using remote room, discharge, and/or outdoor sensors.
Use the following guide to determine the dipswitch settings
for your application.
Using built-in room sensor only.
(This is the default setting.)
Using built-in room sensor with
discharge air sensor only.
Using built-in room sensor with
outdoor air sensor only.*
Using built-in room sensor with
both discharge and outdoor air
sensors.*
Using remote room sensor only.
Using remote room sensor with
discharge air sensor only.
Using remote room sensor with
outdoor air sensor only.*
Using remote room sensor with
both discharge and outdoor air
sensors.*
* (SZ1009, SZ1031 and SZ1035 only)
KEYPAD ACCESS
The dipswitches in the thermostat cover (shown above) must
be set in order to lock the user out of the program and/or to
set the clock and schedule. Use the guide below to set these
dipswitches for your application. User access may also be
limited with an access code set in programming. (The fan and
system switches are enabled or disabled in programming only,
and require no dipswitch placement.)
Keypad access to both
programming and clock setup.
(This is the default setting.)
No keypad access to programming
or clock setup.
Keypad access to
programming only.
Keypad access to clock
setup only.
Once the dipswitches have been set and you have confirmed
that the sensors are reading correctly (and program and clock
setup are finished, if locking out access with dipswitches),
secure the cover to the base with the two set screws located at
the top right and the left side.
1 2 3 4 5
1 2 3 4 5