Tdrum DD-503 User Manual - page 19
DRUM KIT EDIT
(2) Edit another part
Select another part to edit in the same way ex-
plained in Page 13. The current parameter to
edit will keep no change. It provides you easy
method to edit the same parameter for each part.
15
7. Complete the edit
After finish all editing job for the current drum kit,
you may terminate the edit.
Press the EXIT button,
“Save it?”. Then, you
have two choices:
(1) Save edited drum kit as your own user
kit:
Press the ENTER button.
“User Kit” with User
kit number blinking will appear. Rotate the
SCROLL WHEEL to choose number, then press
the ENTER button to confirm.
Note: There are 10 built-in preset User Kit. All
of them are the same as Kit 01. When you save
your own User Kit, it
’ll replace the existing one.
If the saving is successful, it
’ll turn to the Kit
select mode. The indicators of the pad select
button and the EDIT button will turn off.
The display always asks
“Replace it”?. Press
the ENTER button to replace existing one with
your new editing. Press the EXIT button then
change another number. If you really don
’t want
to cover any existing User Kit, press the EXIT
button again, and it will cover the current edited
kit then turn to the Kit Select mode. .
The User Kit setting is nonvolatile even the
power turns off.
(2) Press the EXIT button to exit the edit mode
and return to the Kit Selection mode without sav-
ing as User kit. The indicators of the pad select
button and the EDIT button will turn off.
The edited results will cover the current drum
kit and activate immediately. When the power
turn off, this changes will reset.
Tip: You may reset the kit changes by Reset
feature. Please see
Manual for details.
Save it?
Replace it
User Kit