TE HL-2S Installation Manual - Hl-2S Installation Manual
HL-2S Installation Manual
10
Recievers Functions
10
IRDA In – Used for connecting to a 12V Xantech Compatible Powered Infra-
Red Pickup Device via 3-conductor mini-jack, or to IR encoded signal for Pass-
Thru to the IRDA OUT at the Receiver end. (See diagram on page 12 and 13 for
suggested use)
11
Mini USB (Firmware Update) – For Firmware updates (provided if
necessary) by Transformative Engineering. DO NOT attempt to connect this port for
any other reason. Loss of all operation may result.
12
HDBase-T Link Connection – Connect via Category 5e/6/7 cable to the HL-
2S Receiver Unit ONLY. DO NOT CONNECT THIS RJ-45 CONNECTOR TO ETHERNET.
DAMAGE TO THIS PRODUCT AND YOUR NETWORK MAY RESULT. Recommended
minimum length is 5 Meters up to our maximum rated specification of 70 Meters.
12a
Audio Return Channel – Audio Return Channel (ARC) is incorporated into
the HDMI connector and serves to provide a pathway for the audio signal that
originates from the Display (TV) source. When utilizing ARC-enabled Smart TVs
to “stream” content from internet providers, the audio from that content may be
presented back to the head-end and into ARC-enabled Surround Receivers. This is
effectively a method for bi-directional use of the HDMI signal path. Only Audio from
the ARC-enabled TV may be sent over this method. Please refer to setup instructions
on your AV Surround Receiver and Television display for details.
RECEIVER FUNCTIONS - See Page 8
1
HDMI Output – Connect this to your Display device – TV, Projector, etc. All video
signals input to the HDMI Input on the Transmitter will appear here.
2
ARC Indicator – This light will illuminate whenever a completed audio signal
from ARC or the TOSLINK connection is established.
3
Digital Optical In (SPDIF) – Use the Optical output from a SmartTV as an
alternative to ARC for improved sound.