TE HL-2S Installation Manual - Hl-2S Installation Manual
HL-2S Installation Manual
9
Transmitter Functions
TRANSMITTER FUNCTIONS - See pg 7
1
HDMI Input – Connect this to your HDMI Source – Cable Box, Disc Player, etc.
2
ARC Indicator – This light will illuminate whenever a completed audio signal
from ARC or the TOSLINK connection is established.
3
Digital Optical Out (SPDIF) – Connect to Optical in of Surround Receiver as an
alternative to ARC for improved sound from your SmartTV.
4
Analog Audio Out – This is a 2-channel decoded audio source derived from
the Audio Return Channel or TOSLINK Digital stream from the TV to an amplifier.
5
Power Input – Utilizing the supplied 24V .75A supply, when connected at the
Transmitter side, No Power Supply is necessary at the Receiver side.
6
Power Indicator – This light indicates that power is being supplied to the
unit.Connection of the (included) Power Supply should illuminate this light on both
Transmitter and Receiver Units.
7
HDCP Indicator – This light shows that a valid HDMI connection has been
made, “handshake” has taken place, and there is a High Definition Copy Protect flag
in operation. Attempts to copy Digital content will not be allowed. Any connection
to a non-compliant Digital copy device will cause this light to go off, and will result
in the loss of signal.
8
HDBaseT Link Indicator – These lights show that communication has been
properly established with the HDBase-T Receiver. No other connections need be
made for these lights to indicate your connection is secure. If the “POWER” light is
not on, you should check that the power supply is properly connected.
9
IRDA Out – Used for connecting to an Infra-Red Emitter for controlling a device
at this end. The IR Signal would originate from the Receiver end either from a
Powered Pickup or an IR Pass-Thru. (See diagrams on pages 12 and 13)