Teac CRX350iP Instruction Manual - page 8
0
GETTING STARTED
This CRX350iP is designed to operate on the included AC Adaptor.
AC Adaptor Operation
1. Insert one end of the AC adaptor into the DC JACK on the back of unit.
2. Connect the AC plug of the AC adaptor to an AC 100-240V (50-60Hz) power source.
Note: Unplug the AC adaptor and disconnect the DC Jack when the unit is not in
use for a long period of time.
CLOCK SETTING
NOTE:
i. The Clock has to be set the first time you plug the unit in.
ii.
The Clock is set to default in 24 Hour format mode.
iii. The Clock can only be set in Standby mode.
Setting the Time
To set the current time, for example 6:30 AM.
When you first plug the AC adaptor into the power outlet, the clock display will light up
flashing “
- -:- -”.
1.)
Press and hold the
CLOCK ADJUST Button until “12H” appears and flashes in the
display. The display backlight will become brightened.
2.)
Press the
CLOCK ADJUST Button to confirm while “12H” is flashing. The hour
digits flash to prompt for input.
NOTE:
To switch to
24H format, press the or
buttons once when “
12H” is flashing.
Press the
CLOCK ADJUST Button to confirm and follow the instructions below to
set the current time.
3.)
While the hour digits are flashing, repeatedly press the
or
buttons to
select the correct hour digits.
NOTE:
Make sure the hour is set so that
AM or PM is displayed correctly. There is a PM
Indicator located underneath the Hour digit. The displayed time is PM when the
indicator is lit. The displayed time is
AM when the indicator is off.
4.)
Press the
CLOCK ADJUST Button to confirm the hour setting (6). The minute
digits (00) will now flash to prompt for input.
5.)
While the minute digits (00) are flashing, repeatedly press the
or
Buttons
until the correct minute digits (30) are displayed.
7
INTRODUCTION
FM RADIO
MUSIC PLA
YBACK
ALARM
AND SLEEP
AUXILIAR
Y
INPUT
REFERENCE