Teac GF-450K7 Owner's Manual - Discs
6
How to remove the disc
How to hold the disc
uppermost. (Compact discs can be played or recorded only on
one side.)
of the case and lift the disc out, holding it carefully by the edges.
fluid, benzine or thinner to clean the discs. Such chemicals will
do irreparable damage to the disc’s plastic surface.
and scratches that could cause the laser pickup to “skip.”
temperature for extended periods. Long exposure to high
temperatures will warp the disc.
Playing such discs may cause irreparable harm to the playing
mechanisms.
and ultraviolet rays than ordinary CDs. It is important that they
are not stored in a location where direct sunlight will fall on
them, and away from sources of heat such as radiators or heat-
generating electrical devices.
label side might be sticky and damage the unit.
use any protective coating spray.
the label side. Never use a ball-point or hard-tipped pen, as this
may cause damage to the recorded side.
with this unit will damage the mechanisms and cause them to
malfunction.
business card size, etc.). CDs of this sort can damage the unit:
RW disc, read the precautions supplied with the disc, or contact
the disc manufacturer directly.
the center hole outward towards the outer edge) with a soft, dry
cloth:
Please use CD, CD-R and CD-RW discs bearing the “DIGITAL
AUDIO” mark.
CD
CD-R
CD-RW
This unit CANNOT RECORD CD-R and CD-RW discs designed
for computer systems.
In this manual, although we refer to “CD-R” and CD-RW” discs, we
always mean “CD-R Digital Audio” and “CD-RW
Digital Audio”, even when this is not explicitly stated.
properly recorded by a computer are playable, but this unit
cannot record, finalize nor erase them.
recording, some CD-R/CD-RW discs may not be playable.
the CD standard may not play back correctly in this player.
If you use such discs in this unit, TEAC Corporation and its
subsidiaries cannot be responsible for any consequences
or guarantee the quality of reproduction. If you experience
problems with such non-standard discs, you should contact the
producers of the disc.