Teac LPU191 User Manual - page 6
Remote Control
The remote control uses Infra-Red technology. To use, point it at the
Infra-red sensor on the unit and press the control buttons. If the remote
control signals become weak, check the battery power and ensure that there
are no obstacles in between the remote control and the unit.
REMOTE CONTROL BUTTON FUNCTIONS
1) Skip/Search forward
Press once to skip to next track, press &
hold for search forward
Skip/Search backward
Press once to skip to previous track, press
& hold for search backward
2) Play/Pause
Press once to start to playback. Press
again to enter pause mode
3) +10/-10
In MP3 mode, press to skip 10 track
forward or b
ackward
4) Stop
Press to stop playback or cancel the stored
program
5) Rep/Ran
Press to toggle Repeat/Random function
on or off.
6) Track separation
Press to divide the recording track at
turntable one by one while recording MP3
to USB.
7) Rec Press to start or stop recording
8) Delete Press and hold for a few seconds to delete
the current MP3 file
BATTERY INSTALLATION
The battery compartment is located on the back of the remote control.
1.
Remove the battery compartment door by pressing in on the tab
and lifting it off.
2.
Insert two (2) AAA size batteries (not included) into the battery
compartment following the polarity markings inside the battery
compartment.
3.
Replace the battery compartment door.
BATTERY PRECAUTIONS
Replacement of batteries must be done by an adult.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries.
The supply terminals are not to be short-circuited.
Non-rechargeable batteries are not to be recharged.
Exhausted batteries are to be removed.
Only batteries of the equivalent type are to be used.
Batteries are to be inserted with the correct polarity.
Dispose of batteries properly. Do not dispose of batteries in fire. The batteries may explode
or leak.
If the remote control will not be in use for a long time, remove the batteries and store them
separately.