Teac LPU191 User Manual - page 9
USB Operation (MP3 Playback)
CONNECTING USB DEVICES
The system is able to decode and playback MP3 files stored in connected USB flash drives and SD/MMC
memory cards.
1. Turn the
Function knob (5) to USB or SD.
2. Plug in the USB stick firmly, or if you are using an SD card, insert it
in the direction of the arrow as shown, with the label facing
upwards. Insert straight without bending.
3.
CAUTION: Connecting the USB stick or SD/MMC Card upside
down or backwards could damage the audio system or the
storage media (USB thumb drive/SD/MMC Card). Check to be
sure that the direction is correct before connecting.
4. The system will start reading and playback files in the storage
media automatically after connecting and the Play LED indicator (13) will light up .
NOTES:
-
The USB port does not support connections via USB extension cables and is not designed to
communicate with computers directly.
-
Before disconnecting the storage media, turn the system off or change to another mode to ensure that
data is not lost or corrupted during disconnection.
-
If the storage media is large, the unit may take some time to read the contents.
-
The system can detect and read the file under MP3 format only though the USB port or SD Card slot.
-
Due to variances in MP3 encoding format, some MP3s may not be able to play via the USB socket.
This is not a malfunction of the system.
-
MP3 track format requirement: MP3 bit rate 32 KBPS~256 KBPS.
REMOVING USB DEVICES
To remove the USB drive/Memory Card, turn off the power or switch the function mode to either Phono or
Tuner first. Then pull the USB drive/SD/MMC card out carefully in a straight motion.
NEVER remove the storage media while it is in use, especially during encoding. This will cause damage to
the storage media and result in data loss.
MP3 PLAYBACK CONTROLS
Play / Pause / Stop mode
1.
To interrupt, press the “Play/Pause/Stop button (10) once, the Play LED indicator (13) will be
flashing. Press again to resume normal playback.
2.
If pres
s and hold the “Play/Pause/Stop button (10) for two seconds during playback mode. The
system will go to stop mode.
3.
To start playback again, press the “Play/Pause/Stop” button (10) to start playback, the first track
will start playback and the Play LED indicator (13) will light up.
Skip / Search mode (skip/search up
/ skip/search down
)
1.
During play or pause mode, if “Skip Up” Button (9) is pressed. It will go to next track and then
remain the play or pause mode.
2.
During play or pause mode, if “Skip Down” Button (9) is pressed. It will go back to the beginning
of the track and remain the play or pause mode.
3.
After step 2, press “Skip Down” Button (9) again will go to the previous track and remain the play
or pause mode.
4.
If press and hold the “Skip Up/Down” button (9) during playback, the playing track will go fast
forward or backward until the button being released.
+10 / -10 tracks (using the remote control)
Press the “+10 /-10 button (11) on the remote control to skip tracks more conveniently.