Teac LS-X55 Owner's Manual - What’S In The Box
2
What’s in the box
Connections
Contents
Thank you for choosing TEAC.
Read this manual carefully to get the best performance from
this unit.
What’s in the box . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Check to be sure the box includes all the parts shown below .
Speaker (LS-X55) x 2
Wall mount bracket x 2
Jointing bolt x 4
Owner’s manual (this document) x 1
Warranty card x 1
o
The wall mount brackets and the jointing bolts are attached to
the speakers when you unpack the box . Remove them before
installing the speakers .
o
Keep this manual for future reference .
Connect the speaker terminals to the amplifier terminals using
commercially available speaker cables .
CAUTION
To avoid damaging the speakers with a sudden high-level signal,
be sure to turn off the amplifier before connecting the
speakers .
Right speaker
Left speaker
Speak
er cable
(not supplied)
Speak
er cabl
e
(not supplied)
Amplifier
1
Strip off the insulation from the ends of the cable and twist
the bare strands together to facilitate connections.
2
While pressing the lever, insert the end of the cable to the
terminal, and then release the lever.
Connect the left channel of the amplifier to the left speaker, and
the right channel of the amplifier to the right speaker .
Also make sure to connect:
¥
red terminal of the speaker
e
¥ terminal of the amplifier
Using ¥ side of the speaker cable
^
black terminal of the speaker
e
^ terminal of the amplifier
Using ^ side of the speaker cable
o
Do not insert the insulation coating into the terminal . Insert only
bare wire .
o
Make sure it is fastened securely by pulling the cable lightly .
o
Read the instructions of the amplifier carefully .
o
The maximum rated input signal to the speaker is 80 W per
channel . When connecting to an amplifier having an output
higher than 80 W, be careful not to overpower the speaker with
excessively high volume as this will damage the speaker .