Teac PC-D910i Owner's Manual - page 8
8
•
Place the set on a hard and flat surface
so that the system does not tilt.
•
Do not expose the set, batteries or CDs
to humidity, rain, sand or excessive heat
caused by heating equipment or direct
sunlight.
•
Do not cover the set. Adequate
ventilation with a minimum gap of 6
inches between the ventilation holes
and surrounding surfaces is necessary
to prevent heat build-up’.
•
The mechanical parts of the set contain
self-lubricating bearings and must not be
oiled to lubricated.
•
To clean the set, use a soft dry cloth. Do
not use any cleaning agents containing
alcohol, ammonia, benzene or abrasives
as these may harm the housing.
•
The lens of the CD player should never be touched!
•
Sudden changes in the surround temperature can cause condensation to form and the
Lens of your CD player to cloud over. Playing a CD is then not possible. Do not attempt
to clean the lens but leave the set in a warm environment until the moisture evaporats.
•
Always close the CD door to keep the CD compartment dust-free. To clean, dust the
compartment with a soft dry cloth.
•
To clean the CD, wipe in a straight line from the centre towards the edge using a soft,
lint-free cloth. Do not use cleaning agents as they may damage the disc.
•
Never write on a CD or attach any stickers to it.
MAINTENANCE & SAFETY
Precautions & General Maintenance
CD player and CD handing