Teac SR-L50DAB Owner's Manual - Troubleshooting
If you have problems with your system, look through this chart and see if you can solve the problem yourself
before calling your dealer or TEAC service center.
General
No power
e
Check the connection to the AC power supply.
No sound.
e
Adjust the volume.
e
If muting is on, press the MUTING button.
The sound is noisy.
e
The unit is too close to a TV set or similar
appliances. Install the unit further from them, or
turn them off.
Tuner
Cannot listen to any station, or signal is too
weak.
e
Tune in the station properly.
e
If a TV is near the unit, turn it off.
e
Rotate the antenna for the best reception
position.
Though the FM broadcast is stereo, it sounds
monaural.
e
Press the SELECT/TIMER ADJ button to switch to
the AUTO mode.
‘NO stations Available’ appears on the display.
e
Ensure that DAB coverage exists in your area.
Cannot listen to the selected station.
e
In auto tuning mode, ensure that you have
pressed the SELECT/TIMER ADJ button after you
had select the station.
A burbling sound is heard on some stations.
e
DAB like other digital media is good at producing
quality audio from a low level signal, however if
this signal level is too low a ‘burbling’ sound can
sometimes be heard. To reduce this, try
repositioning your antenna to gain maximum
signal strength.
CD Player
Cannot play.
e
Load a disc with label side up.
e
If the disc is dirty, clean the surface of the disc.
e
Don’t use scratched, damaged or warped discs.
e
Depending on the quality of the disc and/or the
condition of the recording, some CD-R discs may
not be playable.
e
CD-RW discs cannot be played on this unit.
e
Copy-prohibited discs may not be playable.
Sound skips.
e
Place the unit on a stable place to avoid vibration
and shock.
e
If the disc is dirty, clean the surface of the disc.
e
Don’t use scratched, damaged or warped discs.
Remote Control Unit
Remote control doesn’t work.
e
If the batteries are exhausted, change the
batteries.
e
Use remote control unit within the range
(5m/15ft) and point at the front panel.
e
Clear obstacles between the remote control unit
and the main unit.
e
If a fluorescent light is near the unit, put it off.
24