Teac T-H300DAB Owner's Manual - Before Use
3
Read this before operation
voltage as printed on the rear panel. If you are in any
doubt regarding this matter, consult an electrician.
Avoid placing it in direct sunlight or close to a source
of heat. Also avoid locations subject to vibrations
and excessive dust, heat, cold or moisture.
damage to the circuitry or electrical shock. If a
foreign object should get into the set, contact your
dealer.
always pull directly on the plug, never yank the cord.
solvents as this might damage the finish. Use a
clean, dry cloth.
Maintenance
If the surface of the unit gets dirty, wipe with a soft
cloth or use diluted mild soap liquid. Be sure to remove
any excess completely. Do not use thinner, benzine or
alcohol as they may damage the surface of the unit.
Before Use
CAUTION Regarding Placement
To maintain proper ventilation, be sure to leave a
space around the unit (from the largest outer
dimensions including projections) equal to, or
greater than, shown below.
Left and Right Panels : 10 cm
Rear Panel
: 5 cm
Top Panel
: 2 cm
Remote Control Unit
Battery Installation
Remove the battery compartment cover.
Insert two “AAA“ (R03, UM-4) dry batteries. Make
sure that the batteries are inserted with their positive
“+“ and negative “_“ poles positioned correctly.
Close the cover.
Battery Replacement
If the distance required between the remote control unit
and main unit decreases, the batteries are exhausted. In
this case replace the batteries with new ones.
Precautions concerning batteries
“+“ and negative “_“ polarities.
types of batteries together.
be used. Refer to the precautions on their labels.
long time (more than a month), remove the batteries
from the remote control unit to prevent them from
leaking. If they leak, wipe away the liquid inside the
battery compartment and replace the batteries with
new ones.
dispose of old batteries by throwing them in a fire.
3
2
1
The provided Remote Control Unit allows the unit to be
operated from a distance.
When operating the remote control unit, point it towards
the REMOTE SENSOR on the front panel of the unit.
effective range, remote control operation may be
impossible if there are any obstacles between the
unit and the remote control.
appliances which generate infrared rays, or if other
remote control devices using infrared rays are used
near the unit, it may operate incorrectly. Conversely,
the other appliances may operate incorrectly.