THELIGHT 4LIGHT User Manual - page 12
12
2.
Connecting the power cable to the VAC Control Unit
Connect the power cable to the plug located in the rear side of the VDC Control Unit. Connect the
power plug with a mains power outlet.
Danger
To avoid electric shocks and/or damages in the equipment the
power switch located at the VAC Control Unit front panel must be off
before connecting or disconnecting cables.
3.
Connecting VAC Control Unit and lamp head through the extension cable
Connect the connector in the circular
receptacle at the VAC Control Unit front
panel.
Verify the correct alignment of the
connectors before inserting them.
Rotate the locking ring until it clicks into
the lock position.
Connect the same way the other end of
the extension cable in the input
receptacle coming out from the lamp
head.
Disconnecting the extension cable
Grab the connector firmly, turn the ring to unlock it and pull to extract it.
NOTE:
The extension cable is provided with two equal connectors in every end: both can be
connected either in the VAC Control Unit or in the lamp head.
NOTE:
THELIGHT VAC Control Unit has been designed to supply power to the 4LONG, the
4LIGHT or the 6LIGHT lamp heads. With either of these connected the light emitted
will always be correct.