Therapure 100 Instruction Manual - page 4
Locate a level surface on which to place your Therapure
®
air sanitizer and a 120v outlet (follow
warnings described in the
“saFEtY InstructIons & WarnInGs” section of this manual). Position
your Therapure
®
air sanitizer at least one foot (12 inches) a way from the wall.
Plug in the unit. You are now ready to turn on your Therapure
®
air sanitizer!
selecting a setting
Set up your Therapure
®
air sanitizer as described in “Checking the Lamp”. Press the ON button to
activate your Therapure
®
air sanitizer and get ready to enjoy clean, sanitized air according to the
setting you select.
There are three settings controlled by the control knob. The different settings are LOW mode,
MID mode and HI mode. Turn the control knob to rotate through the settings.
3 stage sanitizing Process
Your Therapure
®
air sanitizer has a 3 stage sanitizing process.
First, the three-speed fan draws in
contaminated air at the base.
second, the powerful UV technology kills harmful airborne bacteria,
viruses and molds.
third, sanitized air circulates out of the top and back into the room.
The Therapure
®
air sanitizer UV lamp
should be cleaned after every 3-4
months of use (see the
“clEanInG
& MaIntEnancE” section of this
owner’s manual for full directions).
Before using your therapure
®
air sanitizer,
please read all safety instructions and warnings on
page 2 and the following important information.
Electrical ratings:
Power Ratings:
Power Consumption:
Wall adaptor: 120 Vac, 60 Hz.
10 watts at high fan setting
4 watt UV light bulb
checking the lamp
1. Always make sure your Therapure
®
air sanitizer is
unplugged before you open the unit.
2. Open up the unit by pressing the button on the front of
the unit. Swing back the lid of the unit.
3. Pull out the UV lamp by twisting the lamp assembly handle
counter clock wise and pull straight out.
4. Check that the UV lamp is intact and clean. Do not touch
the glass with your fingers. Fingerprints will significantly
reduce the performance of your air sanitizer.
5. If the lamp needs cleaning, follow the cleaning
instructions described in the
“clEanInG &
MaIntEnancE” section of this manual.
6. If the UV lamp is broken or needs replacement,
contact 1.800.875.8577 or
www.therapureair.com.
7. Reinsert the UV lamp assembly unit and make
sure that the handle is in a locked postition.
8. Close the top of the unit and make sure the top
lid is securely locked in place.
4
5
high
mid
1. Unlock
2. Remove
Lamp
low
power / on&off
OPERATING THE Therapure
®
AIR SANITIZER
OPERATING THE Therapure
®
AIR SANITIZER