Therapure 100 Instruction Manual - page 5
With very little effort, the Therapure
®
air sanitizer delivers sanitized air to your indoor environments.
Keep your Therapure
®
air sanitizer functioning properly by cleaning the UV lamp after every 3-4
months of use to prevent excessive accumulation that may reduce the units performance.
More
frequent cleaning will be necessary if the unit is located in an area with a high level of
airborne contaminants (excessive amounts of smoke, pet dander, etc.).
Before cleaning your therapure
®
air sanitizer, read all safety instructions and
warnings on page 2.
always make sure your air sanitizer is turned off and unplugged before cleaning.
uV laMP saFEtY WarnInG
to prevent exposure to ultraviolet light, disconnect power to the unit before
servicing any part of the therapure
®
air sanitizer.
to clean the uV lamp
1. Turn off and unplug your Therapure
®
air sanitizer.
2. Open up the unit by pressing the button on the front of the unit. Swing back the lid of the unit.
3. Allow the UV lamp to cool for at least 15 minutes.
Do not touch the uV lamp with your hands; use a cloth.
4. Pull out the UV lamp by twisting the lamp assembly handle counter-clockwise & pull straight up.
5. Remove the UV lamp by rotating the bulb until the 2 pins on
each end of the bulb align with the slots: then carefully remove.
6. Holding only the lamp ends, wipe the UV lamp using a clean,
soft cloth with window cleaner, free of oils.
7. Insert the UV lamp back into the lamp assembly. Rotate 90 degrees.
8. Re-insert the UV lamp assembly into the unit.
9. Make sure the handle is locked and in place.
6
7
CLEANING AND MAINTENANCE
1. Unlock
2. Remove
Lamp
Don’t touch the glass
Hold here only
Over time, some particles and dust may accumulate on
the external surfaces of your Therapure
®
air sanitizer.
cleaning External surfaces:
1. Turn off and unplug your Therapure
®
air sanitizer.
2. Use a moist washcloth with a little dishwashing
soap to wipe the outer case surfaces.
3. Do not allow water to slip into the internal parts
as this could damage its functioning and may
result in injury to you.
4. Allow the unit to thoroughly dry before
resuming use.