Therma-Coil Therma-coil User Manual - page 4
1) Measure inside the stove and using a punch and the template provided,
punch two marks in the stove wall.
2) Check again inside and out, remembering the 6” nipples will go through
the holes made in the stove as well as any heat shields that your stove may
have. The Therma-coil should exit out the rear of the stove when possible,
so plumbing to and from the stove is hidden.
3) Remove the pilot drill bit from the hole saw provided and use it to drill
from the inside of the stove through the stove wall and heat shields (if any),
using oil on the bit to help drilling.
4) Double check the measurements of the holes inside and out for proper fit
of the Therma-coil. If the full length cannot stab straight through the stove
wall and heat shields, it may be necessary to drill the heat shields with a
larger hole saw than is provided to get the necessary clearance.
5) Replace the drill bit into the hole saw, and using the hole saw while add-
ing oil often, drill through the stove wall.
6) Screw the first nut onto the threads and run it down to a suitable place on
the nipple, depending on how much nipple will exit out the back of the stove
and how much of the Therma-coil can fit inside the stove.
7) Add the flat washer and gasket washer and place the Thermacoil into the
stove and through the holes. On the outside of the stove, place the gasket,
flat washer, and nut onto the nipple against the heavy steel stove wall.
8) Tighten as much as possible with a wrench to insure no smoke leakage
and a strong mounting.
Installing the Therma-Coil
in the Stove