Thermador VCI236DS Design Manual - Downdraft

186

DOWNDRAFT  

FEATURES & BENEFITS

FULL 13-INCH RISE 

With an over 13-inch intake, the UCVM rises well above even the  

tallest pans. This protects against splatters when cooking and provides 

better performance in capturing steam and smoke — even from the 

front burners.

DOWNDRAFT RECIRCULATION OPTION 

Downdraft recirculation is now available for island or wall applications. 

Combine the performance of the UCVM Downdraft with the odor- and 

grease-capturing filters in the Recirculation Module for the perfect 

ventilation combination for anywhere in your kitchen.

FULL-FACE FILTERS 

Full-face filters combine a filter with a splatter shield in one easy-

to-remove, dishwasher-safe element. These filters maximize grease 

capture without affecting airflow.

PLANNING INFORMATION

MODEL OPTIONS

Thermador Downdraft Hoods are available in 30 and 36-inch 

widths to fit your kitchen plans and are meticulously crafted for 

both function and design. Be sure to reference the correct model 

information in this design guide.

ELECTRICAL SPECIFICATIONS

Be sure your Thermador Downdraft Hood is properly installed 

and grounded by a qualified technician. Installation, electrical 

connections and grounding must comply with all applicable  

local codes.

MODEL

REQUIRED CIRCUIT 

BREAKER

120V AC, 60 Hz

UCVM30FS, UCVM36FS

15 Amp

INSTALLATION CONSIDERATIONS

The information in this design guide provides key features, 

product dimensions, cutouts and installation specifications. 

Before installing a Thermador Downdraft Hood, be sure to verify 

the cutout dimensions and electrical connections. Also, always 

consult with the installation manual packed with the product for 

complete details before installing.

Thermador Downdraft Hoods may be installed in a wall or island 

behind a Thermador non-professional gas, electric or induction 

cooktop to create a convenient cooking center. Refer to the 

appropriate section for additional specifications. 

HOOD WIDTH

Downdraft ventilation units should be the same width as the 

cooking surfaces they are ventilating.

CHOOSING THE CORRECT BLOWER

A variety of interior and exterior blower options (Remote, Inline 

or Integrated) are available for Thermador’s Downdraft Hoods. 

If the unit you have selected does not have a blower, one can 

be purchased separately. Blower selection will vary based on 

the volume of air that needs to be moved and the length and 

location of the duct run. For long duct runs with multiple turns 

and bends, consider using a more powerful blower. For the most 

efficient air flow exhaust, use a straight run or as few elbows  

as possible.

Remote Blowers (VTR Series) 

Depending on your preference and ducting situation, these 

blowers can be mounted on the roof or exterior wall of your 

home. An exterior installation may be more appealing to reduce 

noise in the kitchen.

 Inline Blowers (VTI series) 

 To minimize noise in the kitchen, these blowers are mounted 

along the duct line anywhere between the kitchen and the 

exterior wall. If you have easy access to your duct line (in an attic, 

for example), this may be an appealing option. 

 Integrated Blowers (VTN series) 

These blowers are purchased separately and integrated into the 

hood or onto the downdraft unit at the time of installation. This 

option allows you to select your ideal hood with the exact power 

you require.