Trion Mister-MINI User Manual - page 8

8

Installation

Plumbing:

1   Install a saddle valve (not included) per the instructions printed on the valve 

package

2   Place the compression nut on one end of the water tubing (included) with the 

threads facing toward the tubing end

3   Slide the Delrin sleeve (included) over the tubing with the short beveled end 

toward the nut  Leave 5/32" of tubing protruding beyond the end ot the Delrin 

sleeve

4   Press the insert (included) into the water tubing.  Place the insert against a flat 

surface and press the tubing onto the insert

5   Fasten the tubing assembly securely to the saddle valve, but do not connect 

the other end of the line to the humidifier yet.

6   With the end of the tubing in a bucket or pan, turn on the saddle valve to wash 

the tubing of any debris that may get stuck in the solenoid valve seat

7   Cut off any excess length of water tubing and connect it to the humidifier.  The 

fitting provided on the humidifier is a "push-to-lock".  Simply push the tubing 

into the fitting until it bottoms out.  Some reistance may be felt as the tubing is 

pushed into the fitting.  If removal is required, push down on the ring around 

the tubing and pull the tubing at the same time. (See the illustration below)

8   Turn the saddle valve on and check the tubing and humidifier for leaks.

push-to-lock

fitting

Tubing

Insert

Tubing

Delrin

Sleeve

Compression

Nut

Electrical Connections (24 VAC):