Triple S C12 Operating Instructions Manual - Maintenance

Manual is about: Commercial Cleaner

Summary of C12

  • Page 1

    C12 commercial cleaner read these instruc- tions before operating cleaner operating instructions english ➜ pp.1-9 espaÑol ➜ pág 10-14 franÇais ➜ p. 17-21 index assembling cleaner ..........................2-5 cleaner descriptions ............................5 how to use ................................

  • Page 2: Assembling Cleaner

    1 2 assembling cleaner carton contents a. Upper handle b. Lower handle c. Cleaner body d. Outer bag e. Cord f. Filter bag g.Handle bolt and nut packet (one extra nut included) h. Extra belt a b c e g h f d it is extremely important to read and follow all instruction steps in order. Remove all parts ...

  • Page 3

    Up align upper handle and lower handle as shown. Place upper (b) and lower (c) handle parts on a flat surface, aligning rod sections (d). With hand on sides of handle, push parts together firmly until they “click” and rod sections lock together. Do not press against the rod extending from the lower ...

  • Page 4

    Pull switch lock (n) above on/off switch (o) straight out. Dispose of lock. Note: if tab has come off during assembly, make sure switch is in the off position (down) before plugging cord into an electrical outlet. Place nut in recessed area (l) at back of handle. Hold nut in place while tightening b...

  • Page 5: How to Use

    Hold filter bag collar (a) as shown. Align opening in filter bag with dirt tube (b) inside the outer bag. Push bag collar firmly onto dirt tube. Tuck in filter bag; zip outer bag. 5 the assembled cleaner will look like the drawing. 1. Handle 2. On/off switch 3. Cord hooks: wrap cord around hooks for...

  • Page 6: Maintenance

    Edge cleaning edge cleaning is provided on both sides of nozzle to remove dirt in carpet near baseboards and furniture. Guide either side of nozzle parallel to edge of carpet or furniture. Disconnect cleaner from electrical outlet before attempting to service it in any manner. Do not operate without...

  • Page 7

    26 slip agitator through new belt (with lettering toward outside of clean- er) and position belt in belt guide (c). Push end of belt into opening in cleaner body. Reposition agitator making sure to align flat sides of projection (d) on belt end of agitator with flat sides of slot (e) in cleaner body...

  • Page 8: If You Have A

    8 pull belt off motor pulley as shown. Remove bottom plate as shown in figs. 26 & 27 of “how to replace belt”. Remove agitator from cleaner and discard. Reposition belt and new agitator by referring to figs. 28 to 32. Place hood on cleaner body and press to snap all four latches. Pull up on hood sli...

  • Page 9: Service

    9 service to obtain approved triple s service and genuine triple s parts, contact a triple s authorized dealer. Always identify your cleaner by the complete model number when requesting information or ordering parts. (the model number appears on the bottom of the cleaner.) servicing of double- insul...