Tripp Lite PDU3VN-Series Owner's Manual - Digital Load Meter
A
C
F
B
E
D
MODEM
7
Digital Load Meter
Features
2
If you press and hold this button
B
for 4
seconds you can display the IP Address
assigned to the unit in the LED Amps
display
C
. The default is no address
assigned. If this is the case, “no address”
will display, one letter at a time. If there
is an IP Address programmed, the address
will display 1 digit at a time with dashes
(-) representing dots or periods (.).
Outlets:
During normal operation, the outlets distribute AC power to
connected equipment.
NEMA 5-20R
Cord Retention Bracket:
Provides secure attachment points for connected
equipment cords.
Mounting Brackets:
Use these brackets to mount the PDU.
SNMP Reset Button:
Press the reset button for 3 seconds to reboot the PDU’s
network card. Rebooting the network card will not erase network settings or
interrupt AC power.
PS/2 Port:
Use this port to connect a Tripp Lite ENVIROSENSE
environmental sensor to provide remote temperature/humidity monitoring
and a dry contact interface to control and monitor alarm, security and telecom
devices. Visit www.tripplite.com for ordering information. Note: Do not
connect a keyboard or mouse to this port.
RJ-45 Modem Port:
Reserved for future use.
201007158 93-3038.indb 7
8/30/2010 10:07:37 AM