Tripp Lite PDUH20DV Owner's Manual - Installation
4
3
1-4
A
B
C
C
2
D
E
F
Installation
(continued)
Step
1-4
: Under-Counter Installation:
After repeating Part 1 above, attach the
PDU to a stable mounting surface by
inserting four user-supplied screws
A
through the PDU mounting brackets
B
and into secure mounting points on the
mounting surface.
Step
2
: Connect PDU to a Properly
Grounded Power Source: The
PDUH20DV includes an IEC-320-C19 to
IEC-320-C20 cord set
D
and an IEC-
320-C19 to NEMA L6-20P adapter
E
. Use
this cord set to attach the PDU to a C19
or L6-20R power source such as a Tripp
Lite UPS System. When using the L6-20P
adapter, secure the connection with the Cord
Retention Bracket
F
by using the included
bolts to fasten the two halves of the bracket
around the connection as shown.
The PDUH20HVL6 comes with an attached
NEMA L6-20P input plug. Attach this plug
to a properly grounded AC outlet or to a
Tripp Lite UPS System.
Note: Connect input plug to an AC outlet that does not
share a circuit with a heavy electrical load (such as an
air conditioner or refrigerator).
Step
3
: Connect Equipment to PDU:
Connect equipment to the PDU with user-
supplied IEC-320 interconnection cords.
Be careful not to exceed the load rating for
each outlet nor the total load rating for the
PDU.
14-02-329-933047.indb 4
4/23/2014 3:39:25 PM