Tripp Lite SmartPro Series Owner's Manual - Manual Del Propietario

Manual del propietario

1111 W. 35th Street Chicago, IL 60609 USA

Soporte al cliente: (773) 869-1234  •  www.tripplite.com

Instrucciones de seguridad importantes

14

Montaje

15

Instalación rápida

16

Operación básica

19

Almacenamiento y servicio

23

English

Copyright ©2004 Tripp Lite. Todos los derechos reservados. SmartPro

®

es una marca comercial registrada de Tripp Lite.

SmartPro

®

3U Rackmount

(5000VA)

Sistemas de UPS Inteligentes e Interactivos en Línea 

• 230V Entrada/Salida  

• Opciones de Operación Extendidas 

1

Reemplazo de batería

24

Français

25

Instalación opcional

17

Póññêèé

37

12

Battery Replacement

The policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice.

Regulatory Compliance Identification Numbers

For the purpose of regulatory compliance certifications and identification, your Tripp Lite product has been assigned a unique series number. The series number

can be found on the product nameplate label, along with all required approval markings and information. When requesting compliance information for this product,

always refer to the series number. The series number should not be confused with the marking name or model number of the product.

This product designed and engineered in the USA.

Note on Labeling

Two symbols are used on the label.

V~  : AC Voltage

V    : DC Voltage

Battery replacement should be performed only by authorized service personnel using the same num-

ber and type of batteries (sealed Lead-Acid). Under normal conditions, the original batteries in your

UPS will last many years. See Safety section before replacing batteries. The batteries are designed

for hot-swap replacement (i.e. leaving the UPS in ON mode), but some qualified service personnel

may wish to put the UPS in the OFF mode and disconnect equipment before proceeding.

Procedure

Remove Front Panel and Battery Holding Plate

Disconnect Batteries

Remove/Dispose of Batteries

Add Batteries

Connect Batteries

Attach connectors: black-to-black and red-to-red.

Replace Front Panel

WARNING! 

Batteries can present a risk of electrical shock and burn

from high short-circuit current resulting in serious

injury or death. Battery terminals are in close proximity

to UPS cabinet and special care must be taken to avoid

shorting the batteries including not touching metal 

cabinet and battery terminals simultaneously.

6

5

4

3

2

1

SMARTPRO

®

UPS

1

6

2

5

3

4

200407144 93-2273 SMX5000 UPS Owners Manual.qxd  10/11/2004  12:05 PM  Page 12