Tripp Lite T030-50M Owner's Manual - page 7
7
Operation
On/Off Function
1 To turn on the device, press
. Press
again to activate the
laser.
2 To turn off the device, press and hold
for 3 seconds.
3 When the device is on but not in use, the backlight will shut off within 15
seconds. After 30 seconds of no use, the laser will shut off. The device will
automatically shut off after 3 minutes of inactivity.
Taking Measurements
Single Measurement
Turn on the device and activate the laser. Once the laser is activated, press
to get a single distance measurement. Measurement results will
display on the screen and automatically be stored in the system.
Continuous Measurement
Turn on the device and activate the laser. Once the laser is activated, press and
hold
for 2 seconds to start the continuous measurement function.
The main display will indicate the measured results, and the auxiliary screen
will show the maximum and minimum distances measured.
Area Measurement
Turn on the device and activate the laser. Once the laser is activated, quickly
press
for the
icon to display on the LCD screen. The icon’s bottom
edge will flash. When this happens, do the following:
1 Press
to measure the first edge (length).
2 Press
to measure the second edge (width).
The device will automatically calculate the area and its measurement will
display on the screen. Press
to remove the previous result and
prepare for the next measurement.
17-07-266-9336DE-EN.indd 7
8/22/2017 8:44:12 AM