- DL manuals
- U-Line
- Refrigerator
- 2000 SERIES
- Install Manual
U-Line 2000 SERIES Install Manual
Summary of 2000 SERIES
Page 1
? the built-in undercouter leader since 1962 2000 series refrigerator / freezer beverage centers wine captain® models u-line.Com 2115wc 2175bevc 2115r 2175wcc install guide 2175rf.
Page 2
Safety precautions safety alert definitions.........................................................................................................................................1 general precautions .....................................................................................................
Page 3
U-line safety precautions 1 important important • please read all instructions before installing, operating, or servicing the appliance. • proper installation procedures must be followed when completing an installation or relocation of a unit. Consult the installation guide before any installation b...
Page 4
U-line inspect & plan 2 3 inspect & plan product registration you have received a carton containing your u-line refrigerator, refrigerator freezer, beverage center or wine captain® unit with a package inside containing a use and care guide, a product registration card, and a water line kit. Please c...
Page 5
Prepare site 3 4 prepare site your u-line product has been designed for either free-standing or built-in installation. When built-in, your unit does not require additional air space for top, sides, or rear. However, the front grille must not be obstructed and clearance is required for an electrical ...
Page 6
Product dimensions 4 5 product dimensions 2115r series 2115wc / 2115wcol series 21175rc/rcg/rf series 23-1/16" 34-1/8" 24" 2175r(c)(f) black and white models 2175r(c)(f)s(g) stainless & out door models 2175r(c)(f)s overlay models 24" 24" 34-1/8" 34-1/8" 3-13/16” 23-1/16” 22-5/8” 3-13/16” 3-13/16” 23...
Page 7
Product dimensions 5 34 - 1/8" 23 15-16” 22-5/8" 34 - 1/8” 2175bevcs stainless steel models 2175bevcol wood overlay models 23-1/4” 3 - 13/16” 23 15-16” 3 - 13/16” 34 - 1/8" 24" 22-5/8" 34 - 1/8" 24" 2175wccs stainless steel models 2175wccol wood overlay models 23-1/4” 3 - 13/16” 3 - 13/16” 2175bevc ...
Page 8
Door swing dimensions 6 6 door swing dimensions units have a zero clearance for the door to open 90°. Stainless steel models require 2 1/8” door clearance to accommodate the handle if installed next to a wall. Other site requirements side-by-side installation for a complete refreshment center, insta...
Page 9
U-line self-closing door alignment and reversal 7 1/8" (3.175 mm) 1 2 3 4 7 self-closing doors door alignment and adjustment align and adjust the door if it is not level, or is not sealing properly. If the door is not sealed the unit may not cool properly, or excessive frost may form in the interior...
Page 10
U-line self-closing door alignment and reversal 8 3 4 5 notch 1 2 to reverse the door: remove door: 1. Hold door to keep it from falling. 2. Remove hinge screw pin (1) from top hinge using a phillips screwdriver. 3. Remove door by tilting forward and lifting door off bottom hinge closer inserts. 4. ...
Page 11
U-line wood trim finishing 9 warning to prevent permanent damage to the inner liner of the unit, the wire rack wood trim must be removed from the unit for staining and/or finishing. Allow stain/finish to dry thoroughly (at least 24 hours) in accordance with the stain/finish manufacturer’s instructio...
Page 12
U-line door panel installationl 10 9 door panel installation custom 1/4'' thick door panel insert door panel preparation a custom door panel may be inserted into the doorframe. Custom door panels can be flat or raised, as long as the maximum panel thickness, where inserted into the door reveal (chan...
Page 13
U-line grill overlay installation 11 grille overlay your models grille is designed to accept a wood grille over- lay. An overlay may be used to compliment a door overlay and provides a seamless look for your surrounding decor. Follow the instructions below to prepare and install your grille overlay....
Page 14
U-line grill overlay installation 12 1/4 8-1/2 3-3/32 19-5/8 1/2 1/2 typ 3x 5/16 typ 2x (7/16 ) 5/16 10-5/16 11/64 2-1/8 1/2 22-7/8 23-7/8 full r grille ov erla y dimensions 24 inch models grille drawing 24 inch.
Page 15
U-line grill overlay installation 13 1/4 4-5/32 3-3/32 10-5/8 1/2 1/2 typ 3x 5/16 typ 2x (15/32 ) .275 5-29/32 11/64 2-1/8 1/2 13-7/8 14-7/8 full r grille ov erla y dimensions 15 inch models grille drawing 15inch.
Page 16
Overlay frame 14 frame preparation 2115wcol 2175wccol & 2175bevcol models only an overlay frame covers the door frame to give a built-in appearance. Appropriate hardware and a copy of these instructions will be included with the unit. Important important the thickness of the overlay panel must be 3/...
Page 17
Overlay frame 15 prepare the new overlay panel important important the overlay door panel must not weigh more than 20 lbs. The thickness of the door panel must be 3/4” 1. Place a towel, or similar, soft non-marking material out on a flat clean surface. Be sure the material is large enough to have th...
Page 18
Overlay frame 16 6. Use the door frame holes as a guide to drill pilot holes for the #6x1” pan head screws 7. Attach the door to the overlay using #6x1” wood screws. Important important if you decide to drill pilot holes, remove the wood overlay from the door, and do not use a drill larger then 7/64...
Page 19
Level & install unit 17 12 12 installation leveling information it is recommended that the unit is level. 1. Use a level to check the levelness of the unit from front to back and from side to side. Level should be placed along top edge and side edge as shown 2. If the unit is not level, adjust the f...
Page 20: Installation Guide
? about u-line building on 45 years, u-line has captivated those with an appreciation for the finer things with exceptional design, inspired innovations and attention to even the smallest details. U-line is synonymous with premium built-in undercounter ice making, refrigeration and wine storage appl...