1. DL manuals
  2. U-Line
  3. Wine Cooler
  4. 2175BEVS
  5. Installation Manual

U-Line 2175BEVS Installation Manual

Manual is about: Beverage Center

Summary of 2175BEVS

  • Page 1

    Www.U-lineservice.Com phone (414) 354-0300 • fax (414) 354-7905 service & parts tech lines phone (800) 779-2547 • fax (414) 354-5696 onlineservice@u-line.Com ©2008 u-line corporation 03/2008 2175bevs beverage center and 2175bevol2 beverage center with overlay installation guide.

  • Page 2

    2175bevs/2175bevol2 beverage center www.U-lineservice.Com 2 03/2008 contents 1-follow safety precautions . . . . . . . . . . . . . . . . . . . . . 2 2-inspect and plan . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 exterior cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . 4 ...

  • Page 3

    03/2008 3 www.U-lineservice.Com 2175bev/2175bevol2 beverage center general precautions use this appliance for its intended purpose only and follow these general precautions along with those listed throughout this guide: warning shock hazard — electrical grounding required. • keep the unit unplugged ...

  • Page 4

    2175bevs/2175bevol2 beverage center www.U-lineservice.Com 4 03/2008 after all the protective coating has been removed from the unit/door, clean all stainless steel surfaces with claire stainless steel polish and cleaner or comparable product or a mild detergent and warm water solution and soft cloth...

  • Page 5

    03/2008 5 www.U-lineservice.Com 2175bev/2175bevol2 beverage center product dimensions please note that the unit has adjustable feet that can add one additional inch to height during leveling or to match adjacent cabinets (see figure 26 on page 14). Door swing/clearances information wood overlay unit...

  • Page 6

    2175bevs/2175bevol2 beverage center www.U-lineservice.Com 6 03/2008 side-by-side installation instructions for a complete refreshment center, install your 2175bevs or 2175bevol2 unit beside a u-line refrigerator, ice maker or combo model (see figure 4 for typical cut-out). Note that each side-by-sid...

  • Page 7

    03/2008 7 www.U-lineservice.Com 2175bev/2175bevol2 beverage center to insert a rack in the cabinet: 1. Align the left and right rack channels with the tracks in the cabinet, and ensuring an even track engagement on both sides, gently push the rack into the cabinet until it stops. 2. Before reloading...

  • Page 8

    2175bevs/2175bevol2 beverage center www.U-lineservice.Com 8 03/2008 final finish-only application: 1. Remove all screws securing wood trim to interior components, and remove the trim. 2. Lightly scruff sand the wood trim with 280 or finer grit sandpaper. 3. Remove sanding dust with a clean, dry clot...

  • Page 9

    03/2008 9 www.U-lineservice.Com 2175bev/2175bevol2 beverage center 7. With bottom of door facing up, remove pivot plate (2 screws), flip over, and remount on opposite side of door (figure 11). Be sure angled side of plate faces center. Figure 11 8. Holding door upright with top of door tilted forwar...

  • Page 10

    2175bevs/2175bevol2 beverage center www.U-lineservice.Com 10 03/2008 overlay frame (2175bevol2 units only) frame preparation important the thickness of the wood overlay panel must be 3/4". 1. Use the following instructions to create or have a wood overlay panel created for your Échelon wine captain ...

  • Page 11

    03/2008 11 www.U-lineservice.Com 2175bev/2175bevol2 beverage center prepare the new overlay panel important the overlay door panel must not weigh more than 20 lbs. The thickness of the door panel must be 3/4". 1. Place a towel, or other similar, soft, non-marking material out on a flat clean surface...

  • Page 12

    2175bevs/2175bevol2 beverage center www.U-lineservice.Com 12 03/2008 figure 17 12. Use the door frame holes as a guide to lightly punch pilot holes for the #6 x 1” pan head screws (figure 18). Figure 18 13. Attach the door to the overlay using #6 x 1” wood screws. Important if you decide to drill pi...

  • Page 13

    03/2008 13 www.U-lineservice.Com 2175bev/2175bevol2 beverage center checking door alignment the unit’s door is aligned at the factory before shipment. However, its alignment could have been disturbed during shipment or during overlay frame installation. Important properly aligned, the door should be...

  • Page 14

    2175bevs/2175bevol2 beverage center www.U-lineservice.Com 14 03/2008 electrical specifications caution electrical installation must observe all state and local codes. This unit requires connection to a grounded (three- prong), polarized receptacle that has been placed by a qualified electrician. The...

  • Page 15

    03/2008 15 www.U-lineservice.Com 2175bev/2175bevol2 beverage center 2. Place the unit into the area where it will be installed. Check the door, sides and top for a proper fit. Also test the make sure the door opens and closes freely. 3. Remove grille and place mark on the floor at the front of the u...

  • Page 16

    03/2008 16 www.U-lineservice.Com 2175bev/2175bevol2 beverage center side-by-side installation 1. Remove screws shown (figure 31). Caution be sure to remove and discard screw shown. Failure to do so may cause damage to the bracket and/or unit. Figure 31 2. Place bracket as shown, and re-attach screws...

  • Page 17

    ?2008 u-line corporation publication no. 30225e 03/2008 rev. A u-line corporation, located in milwaukee, wi, is a family operated manufacturer of built-in undercounter icemakers, combo ® icemaker/refrigerators, wine captain ® wine storage units, refrigerators, refrigerated drawers and refrigerator/f...