U-Line 2275DWRWOL Installation Manual - page 10
www.U-LineService.com
10
02/2007
2275DWRWS/2275DWRWOL —
Drawer Model Wine Captain
®
Side-to-Side Adjustment
See Figure 10. The drawer will need a Side-to-Side
Adjustment if, when viewed from the top, the drawer
front is not square with the sides of the cabinet. This is
caused by one of the slides being mounted too far
forward on the unit’s liner.
Minor Adjustment:
Note: The mounting holes on the slide are slightly larger
than the screws’ diameter.
1. Loosen the slide’s mounting screws.
2. Push the slide backward.
3. Retighten the screws (see Figure 11).
Severe Adjustment:
Note: The slides have extra mounting holes that may be
used.
1. Remove the slide’s mounting screws.
2. Reposition the slide so it is the same distance from the
front of the liner as the other slide. Measure to confirm.
3. Mark new drilling holes using different sets of
mounting holes on the slide (see Figure 12).
Note: Front location holes are shown. Corresponding rear
holes will also need to be marked.
4. Drill all the new holes with a #30 drill bit.
5. Remount the slide.
Front-to-Back Adjustment
See Figure 13. The drawer will need a Front-to-Back
Adjustment if, when viewed from the side, the drawer
front is cocked forward or back. This is caused by the front
slide mountings not being level with the rear slide
mountings.
Top View of Unit
Not Aligned Side-to-Side
ULIN_0001c_A
Figure 10
Push Slide
Backward
Loosen
Mounting Screws
ULIN_0001d_A
Figure 11
Mark and Drill New
Mounting Holes
Push Slide
Backward
ULIN_0001e_A
Figure 12
Not Aligned Front-to-Back
Side View of Unit
ULIN_0001f_A
Figure 13