U-Line Echelon CLRCO2175S41 Installation Manual - page 8
www.U-LineService.com
8
03/2008
CLR2160/CLRCO2175 Ice Makers
Other Site Requirements
Power Supply
The unit requires a grounded and polarized 115 VAC,
60 Hz, 15A circuit (normal household current). See
Electrical Specifications on Page 20.
Water Supply
The unit requires a 1/4” O.D. soft copper supply line, or
flexible water supply kit from U-Line, Part No.
WATERHOOKUP. For more information, see Page 15.
Drain
The unit’s generous 7-inch drain connection height
extends the distance the unit can be located from a
gravity drain. For more information see Page 15.
IMPORTANT
Drain can NOT be located directly below unit. Unit has a
solid base that will not allow unit to drain below itself.
Environmental Requirements
Many U-Line models are designed to operate in harsh
outdoor environments. Special considerations include the
following:
• The units are designed to operate between 50°F (10°C)
and 110°F (40°C). High ambient temperatures (110°F
[40°C] or higher) may reduce the unit’s ability to reach
low temperatures and may also reduce the ice
production rate for those models with ice makers.
• If the ambient temperature is expected to drop below
45°F (7°C), drain all water from the unit to prevent
freezing damage not covered by the warranty.
• For best performance, keep the unit out of direct
sunlight and away from heat generating equipment.
• For best performance and life outdoors, place under a
counter or provide shelter of some kind.
• In climates where high humidity and dew points are
present, condensation may appear on outside surfaces.
This is considered normal. The condensation will
disappear when the humidity drops.
Side-By-Side Installation
Instructions CLR2160
For a complete refreshment center, install your CLR2160
Clear Ice Maker beside a U-Line Refrigerator, Combo, or
Wine Captain Model (see Figure 14 for typical cut-out).
Note that each Side-By-Side Installation will be different.
• Cut-out width for a side-by-side installation is the total
of the widths listed under Cut-Out Dimensions in each
unit’s Installation Guide.
For example:
Placing a CLR2160 Clear Ice Maker next to a 2115 series
unit would require a cut-out width of:
15-3/16" + 15-3/16" = 30-3/8".
Placing a CLR2160 Clear Ice Maker next to a 2175 series
unit would require a cut-out width of:
15-3/16" + 24-3/16" = 39-3/8".
• No trim kit is required. However, 1/4-inch space needs to
be maintained between the units to ensure
unobstructed door swing.
• Units must operate from separate, properly grounded
electrical receptacles placed according to each unit’s
Electrical Specifications.
Acceptable
Location
Preferred
Location
for CLR2060
Receptacle
1"
7"
24"
34-1/4"
to
35-1/8"
1/4" Space
Between Appliances
Figure 14
Typical Side-By-Side Cut-Out