U-Reach BD18 SERIES User Manual - page 6
Chapter 2. Function Table
6
8 Setup
1 Auto Start Time
Allow the system to do the Copy, Test, Compare and Copy + Compare functions
automatically.
2 Display Mode
① Basic
② Show Speedr
③ Show Time
3 Button Beep
4 Eject On Start
① Eject All Discs
To eject all trays with disc inside once the system is booted up.
② Do Not Eject
No eject any tray or disc once the system is booted up.
③ Eject Target Only
Only eject target trays with disc inside once the system is booted up.
④ Eject Source Only
Only eject source disc once the system is booted up.
⑤ Eject All Trays
To eject all trays once the system is booted up.
5 Reader Speed
To adjust the reading speed of source drive.
6 Compare Speed
To adjust the speed of drives while comparing.
7 Language
8 Clear Setup
To reset all the function back to manufacturer’s default setting.
9 Advanced Setup
① Power On Time
To set a warm-up time from 5 seconds to 99 seconds.
② Startup Menu
To select which function you would like to show up in the beginning
③ Skip Reader Error
To set skip the read error and keep copying.
④ Change Bad Master
To make the system eject source disc and ask for another one while the
source disc is unreadable for system.
⑤ CD Overburn
Set to copy overburn CD.
⑥ Show HDD Image Name
To show HDD image name or capacity on Copy, Test, Copy + Compare and
Compare function.
⑦ Keep Buffer
To set enable or disable load source to the buffer.
⑧ Boot Password
To enable or disa ble the user administrative password.
⑨ Setup Password
To set up the login password
⑩ Count Password
To set up the counter password
⑪ Eject tray if no disc
⑫ Fast Key
Only available for uSATA