U-Reach MT1600G User Manual - ➁

➁ 

Function Table

10

⌘

MT-G & MT-H Series

Function

Items/Description

1. Copy

Copy data from source HDD to targets.  

(There are four copy modes for selection at function "6.2 Copy Area") 

2. Compare

Comparison between the source and targets to make sure copy accuracy.

3. Copy +

    Compare

Execute compare function automatically after copy.

4. Erase

4.1 Quick Erase

Erase the INDEX of HDD, and take very short time.

4.2 Full Erase

Ease the whole HDD 

4.3 DoD Erase

Erase HDDs three times complying with USA Department of Defense (DoD) standard. 

4.4 DoD EraseComp

Erase HDDs three times complying with USA Department of Defense (DoD) standard 

and bit-by -bit to check if data is completely erased. 

4.5 Secure Erase

The international authorized high standard Secure Erase function. Even HPA/DCO or 

other data area which are not able to load, can be erased all together with this mode.

5. Utility

5.1 Show Disk Info.

Show HDD’s basic information such as HDD model name and capacity. 

5.2 Update System

5.2.1 Update BIOS

Update the system firmware via the HDD. 

5.2.2 Format HDD

Format the HDD with a 2GB FAT partition in order to quickly 

save firmware in the HDD. 

5.3 System Info.

This function will show information of the duplicator system, including controller model 

number and software version.

6. Setup

6.1 Start-up Menu

Select which function is shown first when the system is turned on. Select from item  1~7.

6.2 Copy Area

6.2.1 System and Files

Set to copy source HDD's data area only.

6.2.2 ALL Partitions

Set to copy source HDD's. 

6.2.3 Whole HDD

Set to copy the whole source HDD.

6.2.4 

Percentage(%)

Set up percentage range of HDD for copy.