U-Reach MT1600G User Manual - ➂
➂
How to Copy HDDs
18
3
Auto Skip Lower-Speed HDDs
Enter function 6.3 to setup tolerance speed of target
HDDs. Set to check HDDs’ lowest tolerance speed.
Users can choose “Don’t care” or set the speed value
among 20/40/60~300MB/second. The system will skip
any HDD which cannot reach the minimum speed. This
setting enables to speed up copying and select HDD
speed higher than the setting.
4
Auto Skip Lower-Speed Source
This setting enables to setup whether to check source
minimum speed when run speed-checking task. Select
“Yes” to include source HDD or select “No” to skip
source checking. This function enables to speed up
copying speed and setup minimum speed for source
HDD.
※
Other Utility and Setup
How to check the system firmware version?
●
Enter function "5.3 System Info", by pressing "OK", the version
➤
How to change interface language?
●
Enter function "6.6 Language" to change. Select preferred language, English or Japanese.
➤
How to change the first start-up function when turn on the machine.
●
Enter function "6.1 Start-up Menu" to reset new function as the first to show on LCD.
Choose the most frequently used one as start-up item.
➤