U-Reach V5.30 User Manual - page 24

24

Chapter 2. Function Operation

9-8. Format HDD

This function allows you to format the built-in HDD while the HDD is NOT selected as reading 

source. You can change the source from HDD to other drive in 6.Select Source, page 11. 

Due to the capacity for discs loading is hard to predict precisely and more and more different 

discs coming out. The traditional method of format is not ideal for using on this duplicator. 

This duplicator is able to detect disc capacity and assign a proper partition for the disc’s data 

automatically. You do not have to predict and select CD or DVD partition in the beginning and you 

can check how many discs you can upload from 9-7.Show HDD Info., page 23 This intelligent 

HDD management technology is much easier for HDD management than the old way.

9-9. Load & Copy

This function is for the system to load the source to HDD and make copy synchronously. The 

system will load the source to HDD during the first round of duplication, and the HDD will replace 

the reader drive to be the source in second round of duplication. This special function is very 

convenient for a big copy task. You also can set:

● Load First: The system will load source to HDD first and take HDD as source to copy.

● Synchronous: The system will load the source to HDD and make copy at the same time.

● OFF: To disable Load & Copy function.

**Note:

1  The image file will only be saved temporary if it is loaded to HDD by Load & Copy 

function.

2  If you would like to save the file permanently please load the file to HDD by manual 

(refer to 9-2.Disc to image, page 21)