1. DL manuals
  2. U.S. Amps
  3. Amplifier
  4. Bass Mekanik
  5. Owner's Manual And Installation Manual

U.S. Amps Bass Mekanik Owner's Manual And Installation Manual

Manual is about: T-CLASS digital amplifiers

Summary of Bass Mekanik

  • Page 1

    Hand - crafted in florida, u. S. A. Owners’ manual and installation guide t-class digital amplifiers including bass mekanik.

  • Page 2

    Did you buy the right u.S. Amp? There is a u.S. Amp for every purpose. If your needs require maximum amplifier power into 4 or 2 ohms per channel, or 4 ohms bridged, use one of the xterminator “x” models for the best results. If you have more than a pair of speakers, or if the speakers have multiple...

  • Page 3: Installation

    Installation amplifier mounting: ventilation: amplifier and crossover input: choose an appropriate location to mount the amplifier(s). Make sure your choice is free from excess heat, moisture, and vibration. Under the vehicle seat or in the trunk are common mounting locations. Be sure the amplifier ...

  • Page 4

    Us-x2 us-x2 active electronic crossover model us-x2 made in florida, u. S. A. Fr e q u e n c y o u tp u t g a in b a ss b o o s t lo w h ig h in p u t lo w p ass le ft l e ft l e ft r ig h t r ig h t r ig h t h ig h p ass a m p r e m o te r e m o te g r o u n d p o w e r us-x2r us-x2r o power lo w p...

  • Page 5

    U.S. Amps crossovers feature an isolated input and amplifier section to keep the system free of noise. It is important to ground the crossover input for proper operation. Do not use a floating ground isolator with this or any other u.S. Amps product. The rbg cable is connected. Use a common screwdri...

  • Page 6

    Bridging your u.S. Amp all u.S. Amps listed in the following section can be used in the bridged mode, meaning that both channels of the amplifier are used together as a powerful single channel, usually to drive a group of subwoofers. Since subwoofers come in a wide variety of types and impedances, u...

  • Page 7

    Volts resistance current volts x current watts 20 x 100 5 40 x 400 10 20 4 5 40 4 10 the equation is kind of divided into 2 parts. If you take the time to check this out, you will see what is really cool about amplifier bridging, and why it is so important to pay attention to the numbers. Part one: ...

  • Page 8

    Awg 14 30 amps awg 6 80 amps awg 0 190 amps awg 12 35 amps awg 4 105 amps awg 00 215 amps awg 10 45 amps awg 2 135 amps awg 000 245 amps awg 8 60 amps awg 1 160 amps awg 0000 275 amps getting wired wire gauge and amperage guide once you have established the current needs of your system, it will be o...

  • Page 9

    As mentioned before, most batteries are built for the relatively light chore of starting the engine. Unless you have the room and ambition to install an upgraded high-powered alternator, your system current requirements may exceed the charging capability of your car’s electrical system. When this ha...

  • Page 10: Amplifier

    200 amplifier power and fuse specifications* watts per channel tmtm usa series usa series usa series usa series compe tition bass mekanik copyright 2001 u.S. Amps inc. All rights reserved. *specifications subject to change without notice. Model 4 ohms 2 ohms 1 ohm .5 ohm .25 ohm fuse 400 600 1000 20...

  • Page 11: Amplifier

    200 amplifier performance specifications* tmtm usa series usa series usa series usa series compe tition bass mekanik copyright 2001 u.S. Amps inc. All rights reserved. *specifications subject to change without notice. **measured at 4 ohms at the circuit board. Model 400 600 1000 2000 4300 5600 usa-2...

  • Page 12: Usa-200 / 200X

    One ohm stable stereo amplifier. Made in florida, u. S. A. 24 4db db 2 active xover two - way 100hz input line out max gain usa-400 h i g h f u l l l o w r l r l the 2-way fixed-frequency 100hz crossover can be configured to input the stereo high pass signal at 18db and output the summed- mono low p...

  • Page 13: Stereo Operation

    X gnd right pos right neg rem left pos left neg 12v pos x gnd right pos right neg rem left pos left neg x gnd right pos right neg rem left pos left neg 12v pos 12v pos left speaker(s) left positive left negative right speaker(s) right negative right positive bridged speaker(s) positive negative sour...

  • Page 14: Usa-50Hc, Usa-100Hc,

    Data out sat warning: u.S. Amps require a grounded input connection. Do not use ground-loop isolation devices on the input of your u.S. Amp! Warning: u.S. Amps require a grounded input connection. Do not use ground-loop isolation devices on the input of your u.S. Amp! Usa-50hc, usa-100hc, usa-600, 6...

  • Page 15: Stereo Operation

    Gnd gnd right pos right neg left pos left neg 12v pos 12v pos left speaker(s) left positive left negative right speaker(s) right negative right positive source unit vehicle battery 11 - 15 volts dc positive 12 volt remote turn-on f u s e positive 12 volts to vehicle battery 8 gauge wire negative 12 ...

  • Page 16: Usa-2000 And 2000X

    Usa-2000 and 2000x stereo operation right speaker(s) negative positive left speaker(s) negative positive switched 12 volt output 500ma max vehicle battery 11 - 15 volts dc source unit positive 12 volt remote turn-on f u s e always fuse at battery 300 amps bridged mono not used 12v pos 12v pos gnd gn...

  • Page 17: 4300X

    Rear front front input 4-in-2 rear gain min front gain min max usa-4300 switch one switch one 4 ch low 4 ch low four channel amplifier made in florida, u.S. A. Four channel amplifier made in florida, u.S. A. 4 ch full 4 ch full bass rear front freq freq freq power 50 500 50 500 50 500 one front high...

  • Page 18

    4300x four channel operation 4300x two channel bridged operation left front speaker (s) negative positive right front speaker(s) negative positive left rear speaker(s) negative positive right rear speaker(s) negative positive power output per channel: 4 ohms: 75 watts 2 ohms: 90 watts bridged output...

  • Page 19: 5600X

    Input 4-in-2 rear front front bass gain bass gain max rear gain min front gain min max power bass rear front freq freq freq 50 500 50 500 50 500 usa-5600 five channel amplifier made in florida, u.S.A. Five channel amplifier made in florida, u.S.A. Rbg the 5600x is protected against thermal, over and...

  • Page 20

    5600x five channel operation terminal top view, facing the rear of the 5600x vehicle ground source unit positive 12 volt remote turn-on front left speaker (s) negative positive front right speaker (s) negative positive fr pos rr pos fr neg rr neg gnd 12v pos sub pos sub neg aux 12 volt output 500ma ...

  • Page 21

    Explained t-class tm bass mekanik by u.S. Amps all “amplifiers” digital or analog, really consist of two sections, the and the the , or the “engine” of the amplifier, is highly efficient, losing little energy in the form of heat. The acts as a “transmission” to convert the power supply's energy into...

  • Page 22

    A basic rule of thumb of audio amplifier design dictates that the is than the audible range. This bare minimum is necessary to keep transistor “switching noise” out of the audible signal. To adequately reproduce the audible range, (20hz to 20khz) the “class d” pwm would have to switch at a of 200khz...

  • Page 23

    T-class™ amplifiers operate at a much than most “class d” designs, producing more power into 8 and 4-ohm loads. Correspondingly, the t-class™ output filter is much smaller than that used with “class d”, allowing u.S. Amps t-class™ to operate into various loads without affecting signal quality or fre...

  • Page 24

    Left speaker(s) left positive left negative right speaker(s) right negative right positive source unit positive 12 volt remote turn-on positive 12 volts to vehicle battery min.12 gauge negative 12 volts to vehicle ground. Min. 12 gauge pt-350 rated power @ .05% thd: 8 ohms: 80 watts 4 ohms: 150 watt...

  • Page 25

    Left speaker(s) left positive left negative right speaker(s) right negative right positive source unit note dual power and ground connections positive 12 volts to vehicle battery 8 gauge wire negative 12 volts to vehicle ground. Min. 12 gauge pt-800 8 ohms: 250 watts @ .05% thd 4 ohms: 400 watts @ ....

  • Page 26: Factory Service:

    Factory service: if you have a problem with your u.S. Amp that requires service you can either take it to the dealer, who will send it back to the factory, or you can return it to the factory yourself. If you choose to send it in yourself you must first get a “return authorization” number from u.S. ...

  • Page 27: Never Never Land:

    Rush me the following cool u.S. Amps items. Enclosed is my check or money order for the amount of $________ dollars. Name__________________________ address_______________________ city_________________st_________ zip___________ ph_______________ email address___________________ send in this form with...

  • Page 28: Other Cool Stuff

    Hand-crafted in florida, u. S. A. Painted metal u.S. Amps emblem w/ adhesive back 6.75”l x 2.5”h prices and specifications subject to change without notice. Copyright 2001 u.S. Amps incorporated. All rights reserved. U.S. Amps inc. 7325-100 nw 13th blvd gainesville, florida 32653 (352)-338-1926 fax(...