U.S. Amps Bass Mekanik Owner's Manual And Installation Manual - Usa-50Hc, Usa-100Hc,
Data
Out
SAT
WARNING:
U.S. Amps require a grounded
input connection. DO NOT use
ground-loop isolation devices
on the input of your U.S. Amp!
WARNING:
U.S. Amps require a grounded
input connection. DO NOT use
ground-loop isolation devices
on the input of your U.S. Amp!
USA-50HC, USA-100HC,
USA-600, 600X, USA-1000, 1000X,
USA-2000 and 2000X
Controls and Features
Amplifier Input:
These models feature input isolation and a built-in
voltage divider that will accept input signals from
nearly any source. It is necessary to provide input to
both channels when operating the amplifier. Input
sensitivity is variable from 250mv to 10 Volts.
Active 24dB Low Pass Crossover:
The low-pass crossover can be infinitely
adjusted to “roll off” at 24db per octave
at frequencies between 50Hz and 500Hz. The
c r o s s o v e r c a n b e d e f e a t e d f o r
full-range operation.
Gain Control:
The gain control is water and dust
proof for long life and high fidelity.
The input sensitivity can be infinitely
adjusted from 250mv to 10Volts.
Subsonic Filter:
To optimize amplifier power
in the audible frequencies, a
defeatable 36 Hz subsonic
filter provides a 12dB per
octave roll-off.
WARNING
U.S. Amps require a
.
DO NOT use ground-loop
isolation devices on the
input of your U.S. Amp!
grounded input connection
Remote
Bass Gain:
When the low-
pass crossover
is “ON” the amp-
lifier volume can
be adjusted remotely from the passenger
compartment, independent of the system
volume. The RBG works within the input
volume
range set by the GAIN control,
and is about 75% effective.
The RGB
comes with a knob and 15’ of cable.
Clear Plexiglas Bottom:
U.S. Amps are hand-crafted to a high standard
of quality in our Gainesville Florida factory, and
are thoroughly inspected for both cosmetic
and operational perfection. A clear bottom
panel displays the attention to detail found in
every U.S. Amp.
Smart Amp Technology:
Both models incorporate a SAT
(U.S. Amps’ exclusive Smart Amp
Technology) that precisely
monitors and tracks vital amplifier
information, including the type
and frequency of fault conditions ,
battery voltage, and amplifier
t e m p e r a t u r e .
A
built-in computer stores data that
can be read by the Dealer with a
U.S. Amps data port interface to
aid in system problem-solving. In
addition, SAT keeps permanent
record of the amplifiers’ serial
number and time of operation.
Exclusive
Smart Amp
Technology
14